User manual BEKO DSS05011X

[. . . ] Dear Customer, We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use. If you handover the product to someone else, give the user manual as well. Follow all warnings and information in the user manual. [. . . ] Some types of these detergents also contain specialpurpose washing chemicals such as glass and stainless steel protectors. combined tablet detergents are available as 3in1 , 5in1 , Allin1 etc. They function only up to a specific degree of water hardness. Above this limit regeneration salt and rinse aid must be added. Refer to the instructions on the packaging of the combined detergent whether it is suitable for the hardness level of the water supply. C While using combined tablet detergents contact with the detergent producers if the dishes are wet and/or if you notice limescale spots particularly on glasses after the washing programme is over. When you switch to powder, liquid/gel or tablet detergent from a combined tablet detergent: 1. Make sure that salt and rinse aid Set the water hardness to the highest level and perform an empty run. After the empty washing cycle, review the user manual and readjust the water hardness level so as to suit the water supply. C Depending on the model, salt indicator and/or rinse aid indicator must be enabled again if they were disabled before. rinse aid C The rinse aid used in dishwashers is a special combination used to increase drying efficiency and prevent water or limescale stains on the washed items. For this reason, care must be paid to have rinse aid in the rinse aid reservoir and to use rinse aids produced specially for dishwashers only. Open the lid of the rinse aid reservoir by pressing its latch (B). Fill the reservoir until "MAX" level. Turn the rinse aid amount adjuster manually to a position between 1 and 6 (4). If there are stains on tableware items after washing, level must be increased and if there is a blue trace after wiping them by hand, it must be decreased. This is set to position 4 as factory default. Close the lid of the reservoir by pressing on it lightly. C Wipe clean any spilled rinse aid outside the reservoir. Items not suitable for washing in the dishwasher · Do not wash iron alloy items in the dishwasher. It can get corroded or leave stains on other items. Do not wash cutlery with wooden or bone stems, glued pieces, or pieces that are not resistant to heat, as well as copper and tin-plated containers in the dishwasher. [. . . ] Since the salt granules that will remain under the lid will dissolve during prewash, causing the lid loosen, check the lid once again at the end of the programme. Water hardness setting is low or salt level is insufficient >>> Measure the hardness of the supply water appropriately and check the water hardness setting. Dishes are not placed orderly in the machine. >>> When placing the glasses and other glassware into the basket lean them not against other dishes but the edges or racks of the basket or the glass support tines. [. . . ]