User manual BEKO DVC6522

[. . . ] Fabrics with membrane coating, water-repellent fabrics, functional clothing, fleece fabrics (dry jackets/trousers with removable internal lining separately). Pre-dried, multi-layered, sensitive fabrics made of acrylic fibres, or separate small items of laundry. Also for subsequent drying. page 8 Make sure your hands are dry. Hold the plug only. Connecting the mains plug Condensation container with filter Drum interior light (depending on Control panel model) Low heat. Turn to Off 1 x to the right Press and hold Low heat and turn 5 x to the right Press Low heat until the required level is reached Turn to Off Cleaning the fluff filter The fluff filter consists of two parts. [. . . ] Changing the bulb page 12. Installation Mains connection The compressor in the dryer is ventilated from time to time, which creates a whirring sound. Operation Drying result is not satisfactory (laundry feels too damp). The automatic cleaning process causes a clicking noise. Empty the condensation container page 4. Select any programme using the programme selector. Press the Start/Stop button condensed water is pumped into the container Wait 5 minutes and then empty the condensation container again. Turn the programme selector to Off. Optional accessories (from after-sales service using order number) WTZ 11310 WTZ 11300 WTZ 10290 Drying time too long. – – Defect – – – Spare parts Disposal – – – – – Dryer Washer-dryer stack connection set The dryer can be placed on top of a suitable washing machine with the same width and depth to save space. The dryer must be fastened to the washing machine using this connection set. Same as WTZ 11310, but with pull-out worktop. The process of pumping the condensation into the condensation container generates pumping noises. The humidity in the room increases significantly. Power failure. Moisture sensor The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how damp the laundry is. A thin layer of limescale may build up on the moisture sensors after prolonged use. Clean the moisture sensors using a damp sponge with a rough surface. Do not use steel wool or abrasive materials. Transport – Prepare the dryer see Frost protection. Display status/ service Display/ Remaining time . . . and adapt to indivi Read these instructions before operating the dryer. Additional functions Programme selector Contents Preparation . Fine adjustment of the drying result Important Information . / After-sales service Safety instructions . 13 All buttons are sens need to be touched Pre Only use the dryer inserted. Container Filter h:min Select On/Off for buzzer at the end of the programme. Reduced temperature for delicate fabrics that require a longer drying time; e. g. polyacrylics, polyamide, elastane, acetate silk. Reduces creasing and prolongs the 'reduced ironing' phase after the programme has finished. Buzzer Low heat Reduced ironing Cln Fine adjustment of the drying result Empty the condensation container. Clean the filter in the condensation container if necessary page 9. Rinse the fluff filters under running water page 4. [. . . ] Check the contents before you switch the dryer on. Do not use the dryer if the laundry has been in contact with solvents, oil, wax, grease or paint (e. g. hair styling products, nail varnish remover, stain remover, cleaning solvent, etc. ) Risk of fire/explosion. coal dust, flour) poses a danger: Do not use the dryer Risk of explosion Do not put laundry containing foamed material/rubber in the dryer elastic material may be destroyed and the dryer be damaged due to possible deformation of the foamed material. [. . . ]