User manual BEKO DVC6531

[. . . ] 12-13 USER MAINTENANCE INSTRUCTIONS Emptying the condensed water container . INSTALLATION INSTRUCTIONS Grounding and Electrical connection . 29 14 15 18 21 2 Guide to the machine 1 2 3 4 5 6 Supply cable with plug Condensed water container Drum door Control panel Drain hose for condensed water Four height-adjustable legs 3 Guide to the machine Pushbuttons ­ Door This button is used to open the door (does not stay pushed in). ­ jON / kOFF When the machine is turned on, the "On" indicator will light up if the door is closed. [. . . ] To gently dry delicate fabrics, press this button before starting the cycle. ­ Start Starts the selected program. Function of the pushbuttons "PROGRAM SEQUENCE" indicator The program sequence indicator lamps show the current status of the drying program. "DRYING STAGE REACHED" indicator This indicator shows which drying stage the program has reached. "PROGRAM SETTING" selector There is a range of settings for both "Cottons" and "Permanent Press". In addition, items can be either dried for 20 minutes (incl. a cooling-down phase lasting 8 mins. ) or fluffed in a cool air cycle for 15 minutes. ­ Door This button is used to open the door. ­ ON/OFF When the machine is turned on, the "On" indicator lamp illuminates when the door is closed. When the door is open, the drum is illuminated. ­ Buzzer When activated, the buzzer will sound as the drum rotates during the anticrease cycle. 10 Program selection To select a program A program can only be selected when the machine is turned on. To change a program during drying: Set the program selector to the desired program. The new program will start from the beginning. The tables following on the next two pages list the range of applications for the different programs. Correct procedure: 1 Press the "On/Off" button. 2 Press the "Door" button and load the drum. Set the desired program by turning the program selector either clockwise or counterclockwise. The drum may be cleaned using a suitable stainless steel cleaner following the manufacturer's instructions. Do not hose down the machine or use abrasive cleaners. 15 Cleaning and care Cleaning the heat exchanger The heat exchanger should be cleaned once or twice a year. Open the door. Remove the cover. Turn the lever so that it is vertical. Turn both levers on the heat exchanger so that they are vertical. 16 Cleaning and care Pull out the heat exchanger. ­ and along the two long sides. Stand the heat exchanger lengthwise on a towel until it dries. Replace the heat exchanger in the reverse order. Make certain the heat exchanger is pushed in all the way and that the cover is firmly closed. Otherwise water may leak from the machine. Clean the heat exchanger: ­ at both ends (front and back). 17 Problem solving guide Electrical appliances should only be repaired by qualified personnel. Incorrectly repaired machines may put the user at risk. There are, however, minor problems which can be corrected without contacting the Service Department. What to do if, . the tumble dryer fails to start when turned on? Cause . . Check whether the "On" indicator lights up. [. . . ] Both machines may operate at the same time because each uses maximum about 15 A current. For more information on the electrical connection on the Miele Double Receptacle Box please contact: ­ your Miele dealer ­ the nearest Miele Service Department. 22 Installation The grill below the drum door should never be blocked, as this will prevent a sufficient intake of cold air. Where to install the machine Installation It is possible to install this appliance under a continuous countertop. The machine lid can be removed, if necessary. The tumble dryer can also be placed on top of a Miele washing machine for a stacked installation. [. . . ]