User manual BEKO DVG593

[. . . ] 15 Cleaning the exterior and the control panel. 16 Emptying the condensed water container . 36 2 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: Read all instructions before using the appliance. Do not dry articles that have been previously cleaned, washed, soaked or spotted with gasoline, dry-cleaning solvents or other flammable or explosive substances. [. . . ] ^ When the container is empty, push it back into its opening until it clicks into place. Do not drink the condensed water! 16 Dryer care Cleaning the condenser Removing the condenser ^ Open the door. , To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. Detergent residues, hair and lint in the drying air can penetrate filters and clog the condenser. Particles from the cool air sucked in from the install location can cause blockages. ^ Check the condenser at least twice a year. ^ Clean if necessary. ^ Open the access panel, located on the lower left corner of the machine, using the yellow tool supplied with the machine. Hold the panel when opening it. ^ Remove the panel up and out of the condenser access area. ^ Turn the condenser door lock down and remove the door. 17 Dryer care Checking the condenser ^ Hold the condenser against the light. ^ Turn the condenser lock up. ^ Look through the front and left side (as illustrated above) of the condenser to check for lint. If no lint is visible: ^ Return the condenser. If lint is visible: ^ Clean the condenser as described. ^ Pull out the condenser. 18 Dryer care Cleaning the condenser ^ Rinse the condenser along all sides with warm water as shown in pictures below. Items may shrink. More Dry Normal Less Dry Hand Iron Rotary Iron If items are still damp, dry again using "More Dry". If fabrics are too damp, dry again using "Less Dry". For items to be ironed with a rotary iron. For items that do not require ironing, e. g. For items which require ironing. To prevent moisture loss, roll up the laundry until ready to iron. Wrinkle-free Available drying options Turbo, Gentle, Anti-crease More Dry Normal Less Dry Reduce load size for fabrics that wrinkle easily. Special Programs Available drying options: Anti-crease only available in Fluff, Sturdy Woolens Delicate items which allow machine drying. Program for reducing creasing in delicate items. Individual items to be freshened and fluffed with cool air. Individual items or very small loads, e. g. Take items out immediately after the end of the program while still slightly damp. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 30 min Available drying options Gentle, Anti-crease - Frequently asked questions What if the dryer will not run?Possible fault The "Start/Stop" button was not pressed. The circuit breaker tripped or the dryer is unplugged. Add fabric softener to laundry when washing or select the "Less Dry" setting on the dryer. [. . . ] The warm air exhausting from the dryer will affect the thermostat of the refrigerator, causing it to run continuously. Level the dryer ^ The dryer must be level to ensure safe and proper operation. ^ The machine can be leveled by turning the legs clockwise or counterclockwise as necessary. 32 Installation Installing the decor panel The door can be fitted with a customized door panel (optional accessory) to match the adjacent cabinets. 1/16" - 3/16" (1. 6 - 4. 8 mm) ^ Open the door. ^ A decor panel up to 3/16" thickness can be inserted if the frame sides are pushed forward. ^ Press the frame sides onto the panel und tighten the screws. [. . . ]