User manual BEKO DWD8650X

[. . . ] contents Introduction Welcome Know your dishwasher / specification Standards and testing information / EC declaration of conformity Warning and safety information Electrical Safety Childrens safety General Recycling Energy and water saving What should not be washed in your dishwasher Before first use Turbo Fan Heat Drying System Installation Electrical requirements This appliance must be earthed Fitting a different plug Water inlet hose connection Drain hose connection Installation of dishwasher How to use Water hardness & Regeneration settings Filling the (Water softener) Dishwasher salt Detergent use Filling the detergent dispenser Rinse aid Filling the rinse aid dispenser Loading the Dishwasher Folding plate support rods Three-way split cutlery basket Upper basket height adjustment (Unloaded) Standard loading and testing institute information Operating the dishwasher How to cancel the washing programme How to change the washing programme Unloading the Dishwasher How to clean your Dishwasher Stainless steel door cleaning instructions Filters Upper spray arm Lower spray arm Before calling service / Trouble shooting Guarantee How to obtain service 2 4 4 5 5 5 5 6 6 6 6 6 7 7 7 7 8 8 9 10 10 11 12 12 13 13 14 14 15 15 16 17 17 17 17 18 18 19 19 19 20 23 23 3 Top Spray Removable work top Turbo Fan Heat Drying System Upper basket Upper basket track latch Upper spray arm Heating element concealed behind the liner Lower spray arm Filters Dishwasher salt cap Lower basket Cutlery basket Detergent and Rinse aid dispenser Removable kick plate Programme Selection&Starting Guide On / off indicator light Rinse aid level indicator light & Salt level indicator light Programme starting point Progress indicator lights 1 Wash On / Off 1 PRE-WASH No Heat 2 RAPID 35°C 3 DELICATE 40°C 4 ECONOMY 50°C 5 NORMAL 55°C 6 SUPER 60°C 7 INTENSIVE 70°C 8 AUTO 8 2 Rinse Aid Salt Rinse Dry AUTO SENSING Start / Stop Half Load End Time Delay - h / Remaining Time - min Time Delay 7 3 Key Lock 6 5 4 Programme Knob Half Load button Start / Stop button Door Handle On/Off button specification Load Capacity Height Width Depth Depth/Height (without worktop) Net weight Supply voltage Fuse currrent Total power Heater power Pump powers : 12 Place settings : 850 mm : 598 mm : 598 mm : 570 mm / 820 mm : 51 kg : 220-240 V ~ 50 Hz : 13 A : 1900-2200 W : 2000 W : 125/30 W Display and plus (+) / minus (-) buttons Diameter of plates for : Upper basket : 25 cm max. Lower basket : 31 cm max. Because we continually strive to improve our products, we may change our specifications and designs without prior notice. This appliance has been designed, constructed and distributed in compliance with the safety requirements of EC directives. 4 73/23/EC 89/336/EC 93/68/EC IEC 436/DIN 44990 EN 50242 The dishwasher should only be operated on the voltage specified. For electrical safety, only earthed plugs and sockets should be used. [. . . ] These detergents contain pre-determined amounts of detergent, softening salt and/or rinse aid and therefore can not be adjusted to best suit the requirements of the dishes being washed and the water supply available in your home. 12 Use only rinse aid intended for household dishwashers. The rinse aid is specially formulated to be used in the dishwashers for the prevention of watermarks and scale on dishes and to increase the efficiency of the washing and drying processes. Therefore, make sure that there is adequate amount of rinse aid in the rinse aid dispenser of your machine. You can adjust the amount of rinse aid used during the wash programme by turning the rinse aid dispenser regulator (C). The dispenser regulator (C) may be set between levels 1 and 6 (6 being the maximum amount of rinse aid usage). Your machine is pre-set at the factory to level 4. According to the finish and drying results obtained, adjust the dose of rinse aid by means of the six position selector. (Position 1: minimum dose, Position 6: maximum dose. ) Gradually increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. C E Open the rinse aid dispenser lid by pressing the button as shown in the diagram. Fill up with rinse aid until the container is full to level of max mark . Put the lid (E) on and ensure you hear the clicking sound. Remember to CLOSE the lid after every refill. Make sure you clean any rinse aid that you might have spilled. Dark = sufficient rinse aid Light = add rinse aid 13 Loading the dishwasher correctly will increase the washing, drying and energy performance of your machine. Examine the information given in this section and the information stated in the Programme chart and quick reference card given with the manual. Remove any large scraps of food from the dishes before placing in the dishwasher to avoid clogging the filters. There are three separate baskets, in which you can put your dishes. Place large or heavily soiled items in the lower basket, and small, light or delicate articles in the upper basket. Put forks, small and medium size knives and spoons in the cutlery basket. Place tall, narrow items in the middle of the racks. 1 Folding of racks 3 2 Long-stemmed glasses should lean against the basket, the racks, or the supports not against the dishes. The shelves on the rack are made height adjustable to accommodate tall items. When loading your dishwasher please ensure tall glasses (and/or wine glasses) rest against the sides of the upper basket. Do not allow tall glasses to rest against each other since they may be damaged during washing if not properly supported. [. . . ] Always close pouring spout after each use. Add rinse aid to the dispenser. 20 TROUBLE SHOOTING GUIDE SYMPTOMS SOLUTIONS Remove spots with silver polish. Wash soon after use, or pre-wash items Prolonged contact with salty or highly acidic foods or with undissolved or highly if they will not be washed right away. or pouring detergent directly on flatware. [. . . ]