User manual BEKO FSA21320

[. . . ] In order to ensure a normal operation of your refrigerating appliance, which uses a completely environmentally friendly refrigerant the R600a (flammable only under certain conditions) you must observe the following rules: Do not hinder the free circulation of the air around the appliance. Do not use mechanical devices in order to accelerate the defrosting, others than the ones recommended by the manufacturer. do not destroy the refrigerating circuit. Do not use electric appliances inside the food keeping compartment, other than those that might have been recommended by the manufacturer. [. . . ] If the failure is longer, then the food should be checked and either eaten immediately or cooked and then re-frozen. Generally, this temperature is bellow -18° C lowertemperatures can be obtained by adjusting the thermostat knob towards position MAX. We recommend checking the temperature with a thermometer to ensure that the storage compartments are kept to the desired temperature. Remember to take the reading immediately since the thermometer temperature will rise very rapidly after you remove it from the freezer. Please remember that each time the door is opened cold air escapes and the internal temperature rises. Therefore never leave the door open and ensure it is closed immediately after food is put in or removed. Final Check Before you start using the freezer check that: 1. The interior is dry and air can circulate freely at the rear. The plug is inserted into the wall socket and the electricity supply is switched on. (Item 5) The control panel adjusts the temperature in the freezer and has the following functions: 1 - Orange led - Fast freeze on When you turn the freezer temperature set buton (4) to the max position, the orange led (1) will light and the compressor will run continuously. Remember to turn the thermostat knob back to its previous position once food has frozen. 2 - Green led - electricity on (Voltage) Lights when the appliance is connected to the network and remains lit as long as it is available power supply. LED green does not provide information on temperature inside the freezer. 3 - Red Led - High Temperature Alarm 4 - Setting temperature buton High temperature alarm After the appliance is turned on for the first time the alarm is not active for 12 hours (red led is off). After this period, red led can lights (red led is on) in the following cases: - If the appliance is overloaded with fresh food - If the door is left open by mistake. In these cases the red led will remain lit until the appliance reached the preset temperature. If the red led is on wait for 24 hours before to announce the authorized service. Important: The temperatures obtained inside can vary according to the conditions of use of the appliance: location, ambient temperature, frequency of door opening, degree of loading with food. The temperature setting will be modified according to these conditions. If the red led is on wait for 24 hours before to announce the authorized service. It could be the warm food placed inside the freezer and/or the door who was left open. When you turn the freezer temperature set buton (4) to the max position, the orange led (1) will light and the compressor will run continuously. [. . . ] That the new plug is wired correctly, if you have changed the fitted, moulded plug. If the appliance is still not operating at all after above checks, contact the dealer from whom you purchased the unit. Please ensure that above checks have been done, as a charge will be made if no fault is found. To keep the selected temperature constant, your appliance occasionally switches ON the compressor. [. . . ]