User manual BEKO FSA25300

[. . . ] In order to ensure a normal operation of your refrigerating appliance, which uses a completely environmentally friendly refrigerant the R 600a (flammable only under certain conditions) you must observe the folloving rules: Do not hinder the free circulation of the air around the appliance. Do not use mechanic devices in order to accelerate the defrosting, others than the ones recommended by the manufacturer. do not destroy the refrigerating circuit. Do not use electric appliances inside the food beeping compartment, others than those that might have been reccommended by the manufacturer. [. . . ] The thermostat shall be adjusted in order to obtain the lowest temperature inside the freezer with the fast freeze button and the yellow lamp lighting. After the time necessary to freeze the fresh foods from the freezer is finished, set the thermostat button on a medium position (yellow lamp is not lighting). Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the temperature with an accurate thermometer (see; Temperature Control and Adjustment). Important Note: If there is a power failure do not open the door. Frozen food should not be affected if the failure lasts for less than 19 hours. If the failure is longer, then the food should be checked and either eaten immediately or cooked and then re-frozen. Generally, this temperature is between -18° C and -28° during all working cycle. C We recommend checking the temperature with a thermometer to ensure that the storage compartments are kept to the desired temperature. Remember to take the reading immediately since the thermometer temperature will rise very rapidly after you remove it from the freezer. Please remember that each time the door is opened cold air escapes and the internal temperature rises. Therefore never leave the door open and ensure it is closed immediately after food is put in or removed. Final Check Before you start using the freezer check that: 1. The interior is dry and air can circulate freely at the rear. The plug is inserted into the wall socket and the electricity supply is switched on. avoid accidental disconnection by taping over the switch. Green and red lights will glow and the compressor will start running when the freezer is first time put in to functioning. Item 5 The control panel adjusts the temperature in the freezer and has the following functions: 1 - Fast freeze button 2 - Freezer temperature set button 3 - Orange led - Fast freeze on 4 - Green led - electricity on (Voltage) 5 - Red Led - Alarm Important: The temperatures obtained inside can vary according to the conditions of use of the appliance: location, ambient temperature, frequency of door opening, degree of loading with food. The temperature setting will be modified according to these conditions. If the red led is on wait for 24 hours before to announce the authorized service. It could be the warm food placed inside the freezer and/or the door who was left open. [. . . ] Use luke warm water to clean the cabinet of the appliance and wipe it dry. Use a damp cloth wrung out in a solution of one teaspoon of bicarbonate of soda to one pint of water to clean the interior and wipe it dry. If the appliance is not going to be used for a long period of time, switch it off, remove all food, clean it and leave the door ajar. We recommend that you polish the metal parts of the product (i. [. . . ]