User manual BEKO GNEV320

[. . . ] GNE V322 S GNE V 320 X GNEV320S GNE V322 P Refrigerator Réfrigérateur GNE V322 PX Please read this manual first!Dear Customer, We hope that your product, which has been produced in modern plants and checked under the most meticulous quality control procedures, will provide you an effective service. For this, we recommend you to carefully read the entire manual of your product before using it and keep it at hand for future references. This manual · Will help you use your appliance in a fast and safe way. [. . . ] Remove the filter cover in the fridge compartment by pulling it forward. Take out the water filter by-pass cover by rotating it downwards. (Figure 3-4) foreign particles in the water. It does not purify water from microorganisms. always be pressed during replacement of the water filter or installing the bypass cover. A Warning: Make sure that the "Ice off" mode is active before taking out the by-pass cover. Note: It is normal that a few drops of water drip after the cover has been taken out. Remove the lid on top of the water filter to place it as shown in the figure and turn upwards to lock it. Press ice cancel button on the display again to exit from this mode. Water filter should be replaced every 6 months. The water filter must be removed as shown in the figure when it is going to be replaced or when it will no longer be used and by-pass cover must be attached. It must be made sure that Ice Off mode is active before taking it out. 19 EN Prior to first use of Ice/Water Dispenser C Water mains pressure must not be below 1 bar. C The first 10 glasses of water should not be consumed. C 12 hours must pass to obtain ice C Water mains pressure must not be over 8 bars. from the Ice Dispenser for the first time. If there is not enough ice in the ice dispenser, ice may not be obtained from ice dispenser. C Pumps must be used in case the C Approximately the first 30 cubes of ice to be obtained from the Ice Dispenser must not be used. supply water pressure drops below 1 bar or if a jug is going to be used. C Water system of the refrigerator C Always use the water filter when a jug is not being used. must be connected to the cold water line. It must not be connected to hot water line. C No water may be obtained in the initial startup of the refrigerator. This is caused by the air in the system. To discharge air from the system, press Dispenser latch for periods of 1 minute until water comes from the Dispenser. Water flow may be irregular in the beginning. Irregular water flow will be normalized after the air in the system is discharged. C At the initial startup of the refrigerator approx. 12 hours must pass before cold water can be obtained. C Water mains pressure must be between 1-8 bars for the operation of Ice/Water Dispenser smoothly. For this, check that 1 glass of water (100 cc) can be filled in 10 seconds. 20 EN 4 Preparation C Your refrigerator should be installed at least 30 cm away from heat sources such as hobs, ovens, central heater and stoves and at least 5 cm away from electrical ovens and should not be located under direct sunlight. the room where you install your refrigerator should at least be 10°C. Operating your refrigerator under cooler conditions than this is not recommended with regard to its efficiency. of your refrigerator is cleaned thoroughly. C The ambient temperature of C Please make sure that the interior C If two refrigerators are to be installed C When you operate your refrigerator side by side, there should be at least 2 cm distance between them. for the first time, please observe the following instructions during the initial six hours. [. . . ] · The noise may be caused by the items put onto the refrigerator. Items on top of the refrigerator should be removed. There are noises coming from the refrigerator like liquid spilling or spraying. · Liquid and gas flows happen in accordance with the operating principles of your refrigerator. [. . . ]