User manual BEKO HB60PX

[. . . ] Follow the local laws applicable for external air evacuation. Before connecting the model to the electricity network: - check the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. If in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. [. . . ] · Fixing the decorative telescopic flue Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance is to be installed in the ducting version or in the version with external motor, prepare the air exhaust opening. Adjust the width of the support bracket of the upper flue (Fig. 3). Then fix it to the ceiling using the screws A (Fig. 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. 2. Connect the flange C to the air exhaust hole using a connection pipe (Fig. 4). Insert the upper flue into the lower flue and rest above the frame. Extract the upper flue up to the bracket and fix it with the screws B (Fig. 3). To transform the hood from a ducting version into a filtering version, fit the charcoal filters provided referring to the fitting instructions. · Filtering version Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. To assemble the filtering flue refer to the instructions contained in the kit. If the kit is not provided, order it from your dealer as accessory. The filters must be applied to the suction unit positioned inside the hood. They must be centred by turning them 90 degrees until the stop catch is tripped (fig. 7). · Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. · The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended use of the light reduces the average duration of the bulb. · Replacing halogen light bulbs (Fig. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. Replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands. ·Commands: (fig. 5) mechanical the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III · FILTER REMOVAL WARNING - ENSURE THE APPLIANCE IS SWITCHED OFF AT THE MAINS BEFORE REPLACING THE BULBS AND FILTERS. remove the filters by lifting the recessed handle and lift free from the hood frame. [. . . ] · The labour costs of a Beko approved repairer to carry out the repair What is not covered? · Transit or delivery damage · Accidental damage · Misuse, or abuse. · Cabinet or appearance parts, including knobs and flaps · Accessory items, including ice trays, scrapers, cutlery baskets · Repairs required as a result of unauthorised repairs or inexpert installation that fails to meet the requirements contained in the user instruction book. · Repairs to products used on commercial or non-residential household premises Important notes. · The product is guaranteed for domestic household use only. · The guarantee will be void if the product is installed or used in commercial or non-residential household premises. [. . . ]