User manual BEKO HBG70

[. . . ] Before connecting the model to the electricity network: - check the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. If in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. - This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 phase spur protected by 3A fuse. [. . . ] For the various installations use screws and screw anchors suited to the type of wall (e. g. reinforced concrete, plasterboard, etc. ). If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. The hood is already prepared for the version with which it was ordered. - If the hood is an extractor model, the lever C must be positioned as indicated in Fig. - If the hood is a filter model, the lever C must be positioned as indicated in Fig. · Extractor version The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange D (Fig 1A). The flange D is supplied with the product and should be fixed above the air outlet hole of the hood as indicated in Fig. · Filtering version To transform an extractor hood version into a filter hood version, please inquire with your retailer about purchasing charcoal filters. The filters should be fitted to the extraction assembly inside the hood, by centring them and rotating them 90 degrees, until they click into place (Fig. Close the air outlet opening with the plug B, as indicated in Fig. 4. instructions: - Remove the filters from the cooker hood and wash them in a solution of water and neutral liquid detergent, leaving to soak. - Rinse thoroughly with warm water and leave to dry. - The filters may also be washed in the dishwasher. The aluminium panels may alter in colour after several washes. This is not cause for customer complaint nor replacement of panels. · The active carbon filters purify the air that is replaced in the environment. The filters are not washable nor re-useable and must be replaced at maximum every four months. The saturation of the active carbon filter depends on the frequency of use of the appliance, by the type of cooking and the regularity of cleaning the anti-grease filters. [. . . ] · The labour costs of a Beko approved repairer to carry out the repair What is not covered? · Transit or delivery damage · Accidental damage · Misuse, or abuse. · Cabinet or appearance parts, including knobs and flaps · Accessory items, including ice trays, scrapers, cutlery baskets · Repairs required as a result of unauthorised repairs or inexpert installation that fails to meet the requirements contained in the user instruction book. · Repairs to products used on commercial or non-residential household premises Important notes. · The product is guaranteed for domestic household use only. · The guarantee will be void if the product is installed or used in commercial or non-residential household premises. [. . . ]