User manual BEKO HCA92640BH

[. . . ] Dear Customer, Thank you for preferring a Beko product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use. If you handover the product to someone else, give the user manual as well. [. . . ] Width Depth Height Supply voltage Control Lamp power Air outlet pipe Capacity Motor power Total power Net weight Colour Width Depth Height Supply voltage Control Lamp power Air outlet pipe Capacity Motor power Total power Net weight Colour Please consult the nearest Authorised Service Agent for the installation of your hood. A Remove the protective film (if any) on the hood and flue surface after the installation. Distance between lower surface of the hood and upper surface of the hob should be at least 65 cm. Have a qualified electrician make the electrical connection. Install your appliance so that you can reach the power connection (plug, outlet) easily after installation. Information required for the preparation of the installation place for your hood is given below. 2 Installing the hood onto the wall To install the hood onto the wall, loosen the screws of hanger plates on the motor housing and pull the plates upwards. Then, tighten the screws of the hanger plates. Secure the Ø 150 mm plastic flue adapter onto the top of the body with 3. If you will use Ø 120 mm flue pipe, install Ø 120 mm flue adapter onto it. Affix the installation template onto the installation place of the hood. Drill the points market with (X, Y) (Figure 5) using a Ø 10 mm bit and points market with (Z) (Figure 5) using a Ø 6 mm bit. Bottom surface of the appliance Hammer Ø 10 mm wall plugs (X, Y) into the holes drilled for hanger screws. Hammer 2 x Ø 6 mm wall plugs (Z) into the holes drilled with a Ø6 mm bit for the external flue connection plate. 5x60 hanger screws into the Ø 10 mm wall plugs (Y) you have hammered into the wall. There must be a gap of 5 mm between the screw head and the wall. (Figure 6) Connect the internal flue connection plate to the 6 mm wall plugs (Z) on the wall using Ø 3. Hang the hood onto the screws you have installed into the Y holes. Open the side suction window of the hood by pulling it towards yourself. 5x60 screws through the X holes located inside in order to secure the appliance. Disconnect the product from mains supply before starting flue installation. Fit the sheet metal flue parts around the body. [. . . ] Use low speeds in normal conditions (1-2), and high speed (3) when smell and vapors are intensified. Lights on the hood are intended for illuminating the cooking zone. Using them to illuminate the ambient/kitchen will result with unnecessary power consumption and inadequate illumination. Hood is equipped with a motor having various speed settings. [. . . ]