User manual BEKO HIG 64221

[. . . ] 25 2 Description of the appliance a Trivet b Pan support c Small burner cap d Large burner cap e Burner collar ring f Large burner cap base g Ignition safety device h Ignitor i Burner base j Air inlet with cover plate k Control for burner l Mains connection cable m Plug Depending on country of destination, the appliance may be supplied with or without a plug. The plug shown is for illustration only. 3 Warning and Safety instructions Gas-heated appliances Safety precautions to take if you smell gas ß Turn off the gas emergency control valve immediately. This is usually located near the gas meter. ß Eliminate all sources of ignition in a safe manner. [. . . ] If, despite this, oil or fat does catch fire, do not attempt to put out the flames with water. Use a suitable fire extinguisher or fire blanket, saucepan lid, damp towel or similar to smother the flames. Do not flambé under a cooker hood. The flames could set the cooker hood on fire. Ensure that the flames from the burner do not spread out beyond the base and up the sides of the pan. 9 Warning and Safety instructions Appliance faults In the event of damage or a defect, switch off the appliance immediately. Turn off the gas supply tap, and disconnect completely from the electricity supply. If the appliance has not yet been fully installed, the electricity cable must be disconnected from the supply point. If connected via a plug and socket, switch off at the socket and withdraw the plug. Do not reconnect the appliance to the mains electricity supply until after it has been repaired. If there is any damage to the glass surface the appliance must be disconnected from the mains electricity and gas supplies immediately and not used until it has been repaired. Repairs to the gas and electrical components of this appliance must only be carried out by a suitably qualified person. To switch off: To switch on: ^ Press in the control and then turn anti-clockwise to the large flame symbol. ^ When the flame ignites, keep the control pressed in for 8-10 seconds, and then let it go. If the flame goes out, repeat the procedure, keeping the control pressed in for a few extra seconds. ^ Turn the control clockwise until "ß" is reached. This stops the flow of gas and the flame goes out. Remember: Turn anti-clockwise to switch on, turn clockwise to switch off. Do not try to force the control further. The control cannot be turned anti-clockwise from the small flame symbol to the "ß" position. 13 Using the gas hob Settings Setting ß * & (2x) + / Description of the flame gas is turned off strongest flame outer and inner rings both produce high flames strong flame outer flame ring burns on low, inner flame ring burns on high low flame inner flame ring burns on high very low flame inner flame ring burns on low Control the flame so that it does not spread out beyond the sides of the pan. As the outer part of the flame is much hotter than the centre, the tips of the flames should stay beneath the pan base. Flame tips which extend beyond the sides of the pan merely warm up the air in the room , can damage the pan handles and can be a fire hazard. 14 Using the gas hob Woks This appliance is particularly suitable for wok cooking. ­ Pans with thick bases are preferable as these distribute heat more evenly. [. . . ] Depending on country, a set of jets for conversion to liquid gas is included with the hob. Conversion to another type of gas is described in the separate Installation Instructions supplied with this hob. Gas connection Connection to the appropriate gas supply, or conversion from one type of gas to another should be carried out in strict accordance with current local and national safety regulations by an approved and registered gas installer (e. g. Corgi registered in the U. K. ) who is responsible for the correct functioning of the appliance when installed. Every appliance should have its own isolating valve. [. . . ]