User manual BEKO HSA 29530

[. . . ] In order to ensure a normal operation of your refrigerating appliance, which uses a completely environmentally friendly refrigerant the R600a (flammable only under certain conditions) you must observe the following rules: Do not hinder the free circulation of the air around the appliance. Do not use mechanical devices in order to accelerate the defrosting, others than the ones recommended by the manufacturer. do not destroy the refrigerating circuit. Do not use electric appliances inside the food keeping compartment, other than those that might have been recommended by the manufacturer. [. . . ] ⷠThe information concerning the supply voltage and the absorbed power is given on the marking label placed in the back side of the freezer. ⷠThe electric installation must comply with the law requirements. The manufacturer has no responsibility for any damage to persons, animals or goods which may arise from the failure to observe the specified conditions. ⷠThe appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with the plug, please ask a specialised electrician to change it. ⷠDo not use extension pieces or multiple adapters. This appliance was designed to operate at an ambient temperature between +100C and +430C (SN-T class). If the ambient temperature is above +430C, inside the appliance the temperature can increase. Set up the appliance far from any source of heat and fire. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life. 100 cm from the cookers working with coal or oil; · Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2. Place the appliance in a perfectly even, dry and well ventilated place. The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket. The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance, ambient temperature, frequency of door opening, extent of filling with food of the freezer. The position of the thermostat knob will change according to these factors. Green LED ­ shows that the appliance is supplied with electric energy. Red LED ­ damage ­ lights if the temperature in the freezer is too high. The LED will operate 15-45 minutes after the putting into operation of the freezer, then it must go off. If the LED goes on during the operation, this means that defects have occurred. Orange button­ fast freeze ­ by pushing it the orange led goes on, showing that the appliance entered into the "fast freeze" mode . The exit of this mode is done by pushing the button again, and the orange led goes off. The three LEDs give information about the mode of operation of the freezer. [. . . ] Before defrosting, adjust the thermostat knob to a higher position so that the food stores more cold. - Take out the frozen food, wrap it in several sheets of paper and put them in refrigerator or a cool place. Take the separator panel and put it under the freezer in the direction of the dripping tube. The water which results will be collected in the special tray (separator panel). [. . . ]