User manual BEKO HSA 40550

[. . . ] Their disposal, while preserving the environment, allows the recovery of important raw materials. Make your old appliance useless : - disconnect the appliance from the supply; - remove the supply cord (cut it); - remove the eventual locks on the door to avoid the blocking of children inside, while playing, and the endangering of their lives. The refrigerating apliances contain insulating materials and refrigerants which require a proper recycling. Do not allow children to play with the packing or with parts of it. [. . . ] The manufacturer has no responsibility for any damage to persons, animals or goods which may arise from the failure to observe the specified conditions. ⷠThe appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with the plug, please ask a specialised electrician to change it. ⷠDo not use extension pieces or multiple adapters. This appliance was designed to operate at an ambient temperature between +100C and +320C (SN class). If the ambient temperature is above +320C, inside the appliance the temperature can increase. Set up the appliance far from any source of heat and fire. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life. 100 cm from the cookers working with coal or oil; · Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2. Place the appliance in a perfectly even, dry and well ventilated place. The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket. The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance, ambient temperature, frequency of door opening, extent of filling with food of the freezer. The position of the thermostat knob will change according to these factors. Green LED ­ shows that the appliance is supplied with electric energy. Red LED ­ damage ­ lights if the temperature in the freezer is too high. The LED will operate 15-45 minutes after the putting into operation of the freezer, then it must go off. If the LED goes on during the operation, this means that defects have occurred. Orange button­ fast freeze ­ by pushing it the orange led goes on, showing that the appliance entered into the "fast freeze" mode . The exit of this mode is done by pushing the button again, and the orange led goes off. The three LEDs give information about the mode of operation of the freezer. Before putting into operation, clean the inside of the appliance (see chapter , , Cleaning"). After finishing this operation please plug in the appliance, adjust the thermostat knob to an average position. [. . . ] ⷠIt is advisable to clean the appliance when you defrost it. ⷠWash the inside with lukewarm water where you add some neutral detergent. Do not use soap, detergent, gasoline or acetone which can leave a strong odour. ⷠWipe with a wet sponge and dry with a soft cloth. [. . . ]