User manual BEKO HSA24530

[. . . ] In order to ensure a normal operation of your refrigerating appliance, which uses a completely environmentally friendly refrigerant the R600a (flammable only under certain conditions) you must observe the folloving rules: Do not hinder the free circulation of the air around the appliance. Do not use mechanic devices in order to accelerate the defrosting, others than the ones recommended by the manufacturer. Do not destroy the refrigerating circuit. Do not use electric appliances inside the food beeping compartment, others than those that might have been reccommended by the manufacturer. [. . . ] instruction for use Electric c onnection Your appliance is intended to operate at a single-phase voltage of 230V/50 Hz. Before plugging in the appliance, please make sure that the parameters of the mains in your house (voltage, currect type, frequency) comply to the operation parameters of the appliance. € The information concerning the supply voltage and the absorbed power is given on the marking label placed in the back side of the freezer. € The electric installation must comply with the law requirements. • The earthing of the appliance is compulsory. The manufacturer has no responsibility for any damage to persons, animals or goods which may arise from the failure to observe the specified conditions. € The appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with the plug, please ask a specialised electrician to change it. € Do not use extension pieces or multiple adapters. se tting up This appliance was designed to operate at an ambient temperature between +100C and +430C (SN/T class). If the ambient temperature is above +430C, inside the appliance the temperature can increase. Set up the appliance far from any source of heat and fire. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life. € Please observe the following minimun distances: • 100 cm from the cookers working with coal or oil; • 150 cm from the electric and gas cookers. € Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2. Assemble on the condenser (in the rear side) the supplied spacers. € Place the appliance in a perfectly even, dry and well ventilated place. 3 GB Switc hing off The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket. Instruction for use Freezer operation Temperature adjustment The temperature of the freezer is adjusted by means of the knob assembled on the thermostat (item. 4) , position „MAX” being the lowest temperature. The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance, ambient temperature, frequency of door opening, extent of filling with food of the freezer. The position of the thermostat knob will change according to these factors. [. . . ] The appliance is placed too close to a heat source. The thermostat knob is not in the correct position. Outs ide clea ning • Clean the outside of the freezer by means of a sponge soaked in soapy warm water, wipe with a soft cloth and dry. € The cleaning of the outside part of the refrigerating circuit (motorcompressor, condenser, connection tubes) will be done with a soft brush or with the vacuum-cleaner. [. . . ]