User manual BEKO HSA37540N

[. . . ] In order to ensure a normal operation of your refrigerating appliance, which uses a completely environmentally friendly refrigerant the R600a (flammable only under certain conditions) you must observe the following rules: Do not hinder the free circulation of the air around the appliance. Do not use mechanical devices in order to accelerate the defrosting, others than the ones recommended by the manufacturer. Do not destroy the refrigerating circuit. Do not use electric appliances inside the food keeping compartment, other than those that might have been recommended Advice for recycling of the old appliance /1 Packing Recycling /2 Transport instructions /2 Warnings and special advice /2 Setting up /3 Electric connection /3 Switching off /4 Appliance description /4 Freezer operation /4 Advice for food conservation /4 Defrosting of the appliance /5 Cleaning of the appliance /5 Replacing the interior light bulb /6 Defects finding guide /6 Sfaturi pentru reciclarea vechiului aparat /8 Reciclarea ambalajului /8 Instruciuni de transport /8 Precauii i recomandri generale /9 Modul de instalare a aparatului /9 Conectarea la reeaua electricã /10 Punerea în funciune /11 Prezentarea aparatului /11 Funcionarea aparatului /11 Sfaturi practice pentru eficien maxim /12 Sfaturi practice privind reducerea consumului de Figures that take place in this instruction manual are schematic and may not correspond exactly with your product. [. . . ] If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. If your appliance has a lock, keep it locked and store the key in a safe place, out of the reach of children. If you are discarding an appliance with lock, make sure that, is made ineffective. This is very important so as to avoid children being trapped inside, which may cause their loss of life. Before plugging in the appliance, please make sure that the parameters of the mains in your house (voltage, currect type, frequency) comply to the operation parameters of the appliance. The information concerning the supply voltage and the absorbed power is given on the marking label placed in the back side of the freezer. The electric installation must comply with the law requirements. The earthing of the appliance is compulsory. The manufacturer has no responsibility for any damage to persons, animals or goods which may arise from the failure to observe the specified conditions. The appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with The plug, please ask a specialised electrician If the ambient temperature is above +430C, inside the appliance the temperature can increase. Set up the appliance far from any source of Do not use extension pieces or multiple adapters. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life. The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket. 100 cm from the cookers working with coal or oil; Before putting into operation, clean the inside of the appliance (see chapter , , Cleaning"). After finishing this operation please plug in the appliance, adjust the thermostat knob to an Ensure the free circulation of the air around The appliance, by observing the distances The signalling block must light. Appliance work for about 2 hours without Assemble on the condenser (in the rear side) Putting food inside it. The freezing of the fresh food is possible after Temperature adjustment The temperature of the freezer is adjusted by means of the knob assembled on the thermostat (item. 4) , position , , MAX" being the lowest temperature. The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance, ambient temperature, frequency of door opening, extent of filling with food of the freezer. The position of the thermostat knob will change according to these factors. The signalling system is placed on the front side of the freezer (Item 5). [. . . ] We advise you to defrost the appliance when the quantity of frozen food is the least. Before defrosting, adjust the thermostat knob to a higher position so that the food stores more cold. The intended purpose of this lamp is to assist the user to place foodstuffs in the refrigerator/freezer in a safe and comfortable way. The lamps used in this appliance have to withstand extreme physical conditions such as temperatures below -20 °C. [. . . ]