User manual BEKO MR52

[. . . ] REFRIGERATION · MR 52 (Mains Operated) · MR 62 (Mains or Battery Operated, 12V) 1. 5 cu. ft Mini - Bar (ABSORPTION SYSTEM) Part no: MR52 IB 039901 Beko (UK) Ltd. Beko House Caxton Way Watford Hertfordshire WD 18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko. co. uk website: www. beko. co. uk Printed in Turkey Operating Instructions Congratulations on your choice of a Quality Mini - Bar which has been designed to give you service for many years. DO NOT-connect the Mini - Bar to the electricity supply until all packing and transit protectrs have been removed. · Leave to stand For at least 4 hours before switching on to allow system to settle if transported horizontally. [. . . ] IMPORTANT: Care must be taken while cleaning / carrying the appliance to ovoid touching the ventilation slots, condenser metal wires at the back of the appliance as you might injure your fingers and hands. Important: This appliance is not designed for stacking with any other appliance. Do not attemp to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance. "IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged. " Electrical leads must not come in contact with any part of the appliance: Do not allow children to play with the appliance or tamper with the controls. Beko (UK) Ltd declines to accept any liability should the instructions not be followed 5 IMPORTANT INSTALLATION INSTRUCTIONS 4. Avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the Mini - Bar to run for long periods. Make sure that sufficient room is provided around the appliance to ensure free air circulation. Leave minimum 2 1/2" (60 mm) clearance on sides and 4 inch (100mm) clearance on the rear sides. Do not cover ventilation slots as this will block the dissipation of heat generated at the back. The Mini - Bar should be located on a smooth surface. Ensure that Mini - Bar is level and in firm cotact with the Floor. Refer to "Cleaning and Care" section to prepare your appliance for use. This appliance has been designed to operate in ambient temperatures between +16 and +32 degrees C (60 and 90 degrees F). Therefore if the appliance is installed in an unheated / cold room (E. g. : Conservatory / annex / shed / garage etc. ) then the appliance may not operate and as a result the storage temperature of beverages and food may rise. 6 · Place mini ice cube trays on the evaporator to make ice cubes. · Place large bottles in the Mini - Bar and not on door shelves. · Don't place fiuy drinks or any bottled / canned drink container on the evaporator. · Ensure ventilation slots are clear from any obstruction. · Parts at the back, including condenser will get hot during operation. Take care not to touch these surfaces. 7 REPOSITIONING THE DOOR Follow the step instructions and the diagrams below. Numbers in brackets refer to diagrams. 1. Remove beverages, loose items from door shelves. [. . . ] Please note that during the first 24 hours of use, some odour may be noticed as the protective coating on the heating element is being burnt oft, this is quite normal and is not a fault. MAKING ICE CUBES Fill the mini ice - cube trays supplied 3/4 full with water and place them on the evaporator. with abrsive material. 10 DO'S AND DON'TS DoClean and defrost your Mini - Bar regularly DoEnsure sufficient ventilation is provided around the Mini - Bar Don't- Leave the door open for long periods as this will make the Mini - Bar more costly to run. Don't- Cover the shelves with any material Don't- Store poisonous or any dangerous substances in the Mini - Bar. [. . . ]