User manual BEKO MR53 MINI BAR

[. . . ] · If you are discardina an old refrigerator with a lock or latch fitted to the door, ensure that it is left in a safe condition to prevent the entrapment of children. · This Mini - Bar must only be used for its intended purpose i. e the storing of drinks, penshable beveraaes and fresh food. · Do not dispose of ihe appliance on a fire. Your appliance contains non CFC/HFC substances in the cooling system and in the insulation which are potentially flammable if exposed to fire. [. . . ] · Check the installation and cable connections with the vehicle manufacturer. IF IN DOUBT, CONTACT A QUALIFIED ELECTRICIAN. 4 TRANSPORTATION INSTRUCTIONS 1. The Mini - Bar should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. If during the course of transport the Mini - Bar has been transported horizontally, it must not be operated for at least 4 hours to allow the system to settle. Failure to comply with the above instructions could result in damage occuring to the Mini - Bar. The manufacturer will not be held responsible if these instructions are disregarded. The Mini - Bar must be protected against rein, moisture, water and other atmospheric influences. This product is designed for indoor use only. IMPORTANT: Care must be taken while cleaning / carrying the appliance to ovoid touching the ventilation slots, condenser metal wires at the back of the appliance as you might injure your fingers and hands. Important: This appliance is not designed for stacking with any other appliance. Do not attemp to sit or stand on top of your appliance as it is not designed for such use. Lift the door carefully from the bottom hinge and stand the door safely. Fit the bottom hinge pin on the opposite side ensuring thick section of pin is facing up. locate the door on the bottom hinge, while holding it carefully. Fit top hinge for left hand side door openning which is supplied with the Mini - Bar. To do this; Locate the hinge pin in the door while holding the door away from the Mini - Bar by about 5". Insert the top hinge into the hinge slot. Insert the plastic plug in the slot on the opposite side and fit the two screws. Check that door opens and closes easily and that there are no gaps allowing air into the Mini- Bar. Switch on when required. 8 TEMPERATURE CONTROL AND ADJUSTMENT Operating temperature is controlled by the thermostat at the bottom of the inner liner of Mini - Bar. (See diagram) Setting may be made from 1 to 5, the coldest position. Turn the thermostat knob clock - wise to obtain a colder temperature and vice versa. [. . . ] Loosen frozen trays with a spoon handle or a similar implement. Never use sharp edged obiucts such as knives, forks. Increase the thermostat setting to maximum setting which is 5 to speed up the ice making. Remember to turn the thermostat setting to its usual setting when ice cubes have formed, otherwise the Mini - Bar may become too cold. 9 DEFROSTING Frost will gradually from on evaporator surface of the Mini - Bar will decrease when thick frost accumulates on the evaporator. [. . . ]