User manual BEKO RA610

[. . . ] 2 Star Fridge RA610 BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko. co. uk website: www. beko. co. uk Printed in Turkey Part no: 48 3010 00 01 Revision no: 1 Congratulations on your choice of a quality Fridge which has been designed to give you service for many years. DO NOT connect the appliance to the electricity supply until all packing and transit protectors have been removed. · Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. · If you are discarding an old refrigerator with a lock or latch fitted to the door, ensure that it is left in a safe condition to prevent the entrapment of children. [. . . ] Baked, chilled cooked food, dairy products. The following guidelines and recommendations are suggested to obtain the best results and storage hygiene. When the appliance is switched on for the first time, the thermostat should be adjusted so that, after 24 hours, the average fridge temperature is no higher than 5°C (41°F ). We recommend setting the thermostat half-way between the 1 and 5 setting and monitoring to obtain the desired temperature i. towards 5 you will obtain a colder temperature and vice versa. Some sections of the fridge may be cooler or warmer ( such as the salad crisper and the top part of the cabinet ) which is quite normal. In ambient temperatures above 25°C (77°F), especially in summer, turn the thermostat knob towards 5. In ambient temperatures below 25°C (77°F) turn the thermostat knob to a half way position. Frequent door opening causes internal temperatures to rise, so it is advisable to close as soon as possible after use. In case of a temporary ice build up in the fridge compartment reduce the thermostat setting to 1, monitoring at the same time that the fridge temperature is maximum +5 degrees C (41 degrees F). Once the ice build up disappears and the appliance starts auto defrosting again as normal, then you may increase the thermostat setting, if required. 9 5 4 3 2 1 0 8 STARTING Final Check Before you start using the refrigerator check that: 1. The feet have been adjusted for perfect levelling. The interior is dry and air can circulate freely. Clean the interior as recommended under "CLEANING AND CARE. " 4. Insert the plug into the wall socket and switch on the electricity supply. When the door is open the interior light will come on. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. Slight undulation of the top of the cabinet is quite normal due to the manufacturing process used, so do not worry, it is not a defect. We recommend that you set the thermostat knob at 3 (three) and monitor the temperature to ensure the appliance maintains desired storage temperatures (See section Temperature Control and Adjustment). Do not load the appliance immediately it is switched on. [. . . ] · The cost of functional replacement parts, but excluding consumable items. · The labour costs of a Beko approved repairer to carry out the repair. · Transit, delivery or accidental damage or misuse and abuse. · Cabinet or appearance parts, including knobs, flaps, handles or container lids. [. . . ]