User manual BEKO TLDA662

[. . . ] Tall Larder Fridge TLDA 662 BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko. co. uk website: www. beko. co. uk Printed in Turkey Part no: 48 4658 00 00 Revision no: 0 Congratulations on your choice of a service for many years. quality Appliance which has been designed to give you CONTENTS PAGE WARNING !DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. · Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. · If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of young children. [. . . ] Set the thermostat knob to ensure an average of +5 °C (40°F) is achieved in the fridge and between -1. 5 °C and +3°C is achieved in the Chiller Zone Compartment after 24 hours. 2) shows how you can switch off the appliance completely: Turn the thermostat knob to "0" (Zero) position. The average temperature inside the fridge depends on the following factors: · Ambient temperature in the room (seasonal changes) · Frequency of door opening · Placing hot food inside the product · Position of the product We recommend that you check the temperature with an accurate thermometer to ensure that the storage compartments are kept to the desired temperature. Remember you must take your reading very quickly since the thermometer temperature will rise very rapidly after you remove it from the appliance. Please remember each time the door is opened cold air escapes and the internal temperature rises. Therefore never leave the door open and ensure it is closed immediately after food is put in or removed. In case of a temporary ice build up in the fridge compartment, reduce the thermostat setting to 1. Once the ice build up disappears and the appliance starts auto defrosting again as normal, then you may increase the thermostat setting, if required. 10 degrees C 1 to 2 16 degrees C 1 1/2 to 2 1/2 20 degrees C 2 to 3 25 degrees C 2 1/2 to 3 1/2 32 degrees C 2 1/2 to 4 If above settings could not maintain the required temperatures, then adjust the thermostat knob accordingly; to obtain a colder temperature, turn the thermostat knob towards 5 and vice versa. *Also see factors affecting temperature inside the fridge on page 8 and adjust it accordingly to suit your specific situation. 9 1 2 10 STARTING Final Check Before you start using the refrigerator check that: 1. The front feet have been adjusted so the appliance is level. The interior is dry and air can circulate freely. Clean the interior as recommended under "CLEANING AND CARE. " 4. Insert the plug into the wall socket and switch on the electricity supply. When the door is open the interior light will come on. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. 6. We recommend that you set the thermostat knob at 3 (three) and monitor the temperature to ensure the appliance maintains desired storage temperatures (See section Temperature Control and Adjustment). Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the temperature with an accurate thermometer (see; Temperature Control and Adjustment). Important Note : Ice formation at the back is normal, do not worry. (See Defrosting) DEFROSTING The larder refrigerator defrosts 1 automatically. [. . . ] · The cost of functional replacement parts, but excluding consumable items. · The labour costs of a Beko approved repairer to carry out the repair. · Transit, delivery or accidental damage or misuse and abuse. · Cabinet or appearance parts, including knobs, flaps, handles or container lids. [. . . ]