User manual BEKO TZDA568F

[. . . ] · This freezer must only be used for its intended purpose i. e. the storing and freezing of edible foodstuff. · Do not dispose of the appliance on a fire. At BEKO, the care and protection of our environment is an ongoing commitment. [. . . ] The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. We recommend that you set the thermostat knob at 3 (three) and monitor the temperature to ensure the appliance maintains desired storage temperatures (See section Temperature Control and Adjustment). Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the temperature with an accurate thermometer (see; Temperature Control and Adjustment). If there is a power failure do not open the door. Frozen food should not be affected if the failure lasts for less than 25 hours. If the failure is longer, then the food should be checked and either eaten immediately or cooked and then re-frozen. If you find the freezer door difficult to open just after you have closed it, don't worry. This is due to the pressure difference which will equalise and allow the door to open normally after a few moments. You will hear a suction sound just after closing the door. To start defrosting procedure switch off the freezer at the socket outlet and pull out the mains plug. All food should be wrapped in several layers of newspaper and stored in a cool place (e. g. Fold out the spout, place a bowl underneath the spout to collect the water. Ensure you use a bowl large enough to contain the defrost water. Normally the volume of the bowl should be about 4 (four) litres. Containers full of warm water may be placed carefully in the freezer to speed up the defrosting. Do not use pointed or sharp edged objects such as knives, forks to remove the frost. Never use hairdryers, electrical heaters and other similar electrical appliances for defrosting. When defrosting has finished, fold back the spout and dry the interior thoroughly. Insert the plug into the wall socket and switch on the electricity supply. Don't- Leave the door open for long periods as this will make the freezer more costly to run. [. . . ] · Repairs necessary as a result of faulty materials, defective components or manufacturing defect. · The cost of functional replacement parts, but excluding consumable items. · The labour costs of a Beko approved repairer to carry out the repair. · Transit, delivery or accidental damage or misuse and abuse. [. . . ]