User manual BEKO WMA17151

[. . . ] installation & operating Automatic instructions and washing guidance washing machine WMA 1715 W WMA 1715 S a welcome Dear customer Congratulations on your choice of a Beko quality washing machine which has been designed to give you lasting service. Please read these instructions thoroughly before installing or using - and keep for handy reference. Make sure you understand the controls prior to using your appliance. The washer must only be used for its intended purpose, ie the washing of clothes in the home. [. . . ] When the desired programme is selected, related spin speed can be adjusted. It means the washing machine is ready to add laundry. If door open led is not lit up after 1-2 minutes, it means the water level inside the machine is too high and it is not allowed to open the door and add laundry. If you change your mind as not adding laundry, repress Start/Cancel/Pause button to let the programme continue. Warning!When the machine is turned on, the led of the selected programme on the knob will light up. If there is no light on the programme selection knob and the led of the "Conditioner" is blinking, it means that programme selection knob is stuck between two programs. In that case, the knob should be adjusted on the correct programme again. If the programme selection knob is turned while the machine is on and executing the selected programme , all led on the programme selection knob will be off. When the knob is set to selected programme again, related led will be on. 10 Re-Selection / Cancellation of Functions After Operation Start In order to change auxiliary functions, spin speed or temperature , push the Start/Pause/Cancel button for a short time to pause the program. Change the auxiliary functions , spin speed or temperature from the available ones which the program step allows. Then push the Start/Pause/Cancel button for a short time to continue the program. Programme Cancelling If the programme has not started yet, you can cancel the selected programme by pressing Start/Pause/Cancel button for 3 seconds. After 3 seconds the led of the Start/Pause/Cancel button will be off and the led of the selected programme will be on, where it is possible to set a new programme If the programme has started and you want to cancel it, press Start/Pause/Cancel button for 3 seconds. The programme will move to the "Spin" step and related led on the programme follower will be on. Machine will start to pump for draining and the door can be opened after the door open led is on. End of the programme If all the wash programs are finished, all the leds on the programme follower will be on. At the end of the washing, all related leds on the control panel will be on. To switch off the machine, press the On/Off button. Unloading The machine stops automatically after programmes are completed. In 1-2 min, after the door open led lights up, press the door open button and open the door. 2 Press the On/Off button to switch off the machine. 3 Unload the machine and leave the front door open. Check to see if there is any water left in the door hood. If so, remove with a soft cloth. 11 programme descriptions Cottons Cotton 90, Cotton 60, Cotton 40, Intensive 60 Programmes These programmes are used for white and coloured cotton and linen fabrics. Cotton 90 Programme with main wash (main wash, 3 rinses, 3 intermediate spin, final spin). [. . . ] (Max 5. 5 kg dry weight) Water coming from beneath the machine Check the water inlet and drain hoses. The washers of the hoses may be worn out or the pump filter may not be closed properly. Foam coming out of the detergent dispenser Check whether your detergent is suitable for automatic machines. Next time use less detergent. Pump does not drain water Check Rinse Hold button has not been selected in error. Do not attempt to remove the filter if the machine is full of water. [. . . ]