User manual BEKO WSA 29000

[. . . ] Children should be supervised to ensure that they do not play with the appliance. Advice for the recycling of your old refrigerating appliance If the new show-window refrigerator replaces an older one, you should comply with some things. The old appliances aren't valueless wastes. Their removal according to ambient environment allows the recovering of some important raw materials. [. . . ] Before connecting the appliance to the mains, be sure that the mains parameters of your house (voltage, current type, and frequency) are according to the working parameters of the appliance. The information concerning the supply tension and absorbed power are given in the marking label, placed inside on the side, which can be seen after drawing the crisper. The electric installation must be done according to the law requirements. The manufacturer is not responsible for the eventual problems occurred to persons, animals or property due to the nonobservance of the above-mentioned conditions. the apliance has a supply cable and a plug (European type , marked 10/16A) , with double earthing. If the plug is not the same type as the socket, ask a specialised electrician to change it. The appliance is designed to operate in class 4H2 according to SR EN ISO 23953-2 ambient temperature 300C!5% - which should be kept relatively constant. Assembly the appliance far from any heat source. Placing the appliance in a warm room, exposing it directly to sunshine or placing it near a heat source ( heaters, cookers, ovens) results in energy consumption increase and reduce the life of the appliance. Please observe the following minimal distances: - 100 cm from the cookers with coal or petrol; - 150 cm from the electric and/or gas cookers Provide free air circulation around the appliance, by observing the distances mentioned in the drawings (Items 2&3). Put the back airing lid to the back of your refrigerator to set the distance between the refrigerator and the wall (Item 3). Place the appliance in a dry and well ventilated place, perfectly even, adjusting the front feet if necessary (Item 4). Before starting the appliance, clean the inside of the appliance. After doing this, connect the appliance to the mains. adjust the thermostat buttons on an average position. For inside lighting, ajust button of the signalling block on medium position . 2 hours without placing inside any beverages or food inside. The internal temperature could be adjusted by means of the button from the thermostat. The temperatures obtained inside the appliance could oscillate depending on the usage conditions: location, environmental temperature, doors opening frequency, foods quantity. This position can be adjusted subsequently towards plus or minus according to the user's wish The thermostat (placed in the rear side of the appliance, in the ventilation grill) also assures the automatic defrost of the refrigerator. During the defrost period the temperature inside the refrigerator could reach up to +120C, but it decreases up to 2-30C. [. . . ] Appliance does not work There is an energy cut-off. The appliance does not cool There was an energy cut-off for a longer period of time. The appliance is too near of a heat source. The thermostat button is not on the correct position. [. . . ]