User manual BEKO ZA635FW

[. . . ] 3. 1 cu. ft. ZA95F BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 0845 6004911 Fax: 0845 6004922 e-mail: service@beko. co. uk website: www. beko. co. uk Congratulations on your choice of a service for many years. quality Appliance which has been designed to give you WARNING !DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. · Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. · If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of young children. [. . . ] Make sure that you tilt the appliance on its back side, otherwise compressor oil may block the pipes and you may damage the appliance. Unscrew and remove the LHS front feet and bolt (2). Unscrew the bolts and remove the bottom hinge while holding the door (3). Remove the door carefully from the top hinge by sliding downwards (4). Reposition top hinge bushing and blanking plug on the opposite side and stand the door safely (5). You may find it easier to remove the bushing and the plug with the tip of a small screwdriver. Reposition the top hinge on the opposite side (6 and 7). To refit the door, locate the top hinge in the door, attach to the cabinet and hold the door (8). If necessary adjust and then tighten the bolts. Ensure, that the door opens and closes easily and that there are no gaps allowing air into the cabinet. If there are gaps between the door seal and the cabinet, adjust the door seal by gently pulling away from the door using fingers. (You may need somebody to help you. ) Adjust the front feet (See Installation Instructions) 13. Wait for at least 4 hours to allow the system to settle before switching on. Spare plastic parts supplied with the appliance are for your future use during door repositioning. 7 STARTING Final Check Before you start using the fridge/freezer check that: 1. The feet have been adjusted for perfect levelling. The interior is dry and air can circulate freely at the rear of the cabinet. Clean the interior as recommended under "CLEANING AND CARE. " Insert the plug into the wall socket and switch on the electricity supply. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. "Due to operation of the fan, overall noise level is slightly higher in comparison to nonfrost free appliances. This is quite normal and is not a fault. " Set the setting knob half way between 1 and 4. Front edges of the cabinet may feel warm. [. . . ] · Cabinet or appearance parts, including knobs, flaps, handles or container lids. · Accessories or consumable items including but not limited to, ice trays, scrapers, cutlery baskets, filters and light bulbs. · Repairs required as a result of unauthorised repair or inexpert installation that fails to meet the requirements contained in the user instruction book. · Repairs to products used on commercial or non-residential household premises. [. . . ]