User manual BEKO ZA90

[. . . ] Upright Freezer ZA 90 ZA 130 BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko. co. uk website: www. beko. co. uk Printed in Turkey Part no: 48 3452 00 00 Revision no: 0 Congratulations on your choice of a service for many years. quality Appliance which has been designed to give you WARNING !DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. · Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. · If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of young children. [. . . ] Unscrew the bolts and remove the bottom hinge while holding the door (3). Remove the door carefully from the top hinge by sliding down wards (4). Reposition top hinge bushing and blanking plug on the opposite side and stand the door safely (5). You may find it easier to remove the bushing and the plug with the tip of a small screwdriver. Reposition the top hinge on the opposite side (6 and 7). To refit the door, locate the top hinge in the door, attach to the cabinet and hold the door (8). If necessary adjust and then tighten the bolts. Ensure, that the door opens and closes easily and that there are no gaps allowing air into the cabinet. If there are gaps between the door seal and the cabinet, adjust the door seal by gently pulling away from the door using fingers. (You may need somebody to help you. ) Adjust the front feet (See Installation Instructions) 13. Wait for at least 4 hours to allow the system to settle before switching on. Spare plastic parts supplied with the appliance are for your future use during door repositioning. 10 9 6 7 STARTING Final Check Before you start using the freezer check that: 1. The feet have been adjusted and the product is level. The interior is dry and air can circulate freely at the rear. Clean the interior as recommended under "CLEANING AND CARE. " 4. Insert the plug into the wall socket and switch on the electricity supply. Avoid accidental disconnection by taping over the switch. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. Slight undulation of the top of the cabinet is quite normal due to the manufacturing process used, so do not worry, it is not a defect. Front edges of the cabinet may feel warm. These areas are designed to be warm to avoid condensation. [. . . ] · The cost of functional replacement parts, but excluding consumable items. · The labour costs of a Beko approved repairer to carry out the repair. · Transit, delivery or accidental damage or misuse and abuse. · Cabinet or appearance parts, including knobs, flaps, handles or container lids. [. . . ]