User manual BELINEA 101910

[. . . ] [ USER MANUAL LCD-Monitor Belinea 10 19 10 ] BELINEA PREMIUM SERVICE English The three-year return to base warranty for your Belinea monitor includes all parts and labour. In addition many countries offer a free of charge swap out warranty programme. This does not affect your Statutory Rights. Please visit http://www. belinea. com or call the numbers below for further warranty or service information. [. . . ] To unplug the cord, always pull on the plug and not on the cable itself. Damage to the power cord may result in fire or cause electric shocks. CARING FOR YOUR LCD MONITOR First, unplug the power cord from the wall socket. If the LCD screen is extremely dirty, clean it with a moist cloth. Use only warm water and then wipe the monitor dry. Solvents or harsh cleaners can damage the housing. Clean the display surface only with a soft cloth, otherwise you may damage the display's coating. If the monitor is only slightly dirty, clean it using a soft, dry and antistatic cloth. The LCD monitor's screen surface is very sensitive. Please avoid any contact with the surface (finger, pencil, etc. ) and be especially cautious during transportation since jolts and shocks can cause the screen to become scratched (always use the original packaging). WALL MOUNTING The Belinea monitor is shipped with the standard desktop configuration. However, you can optionally mount the device on a wall or on a monitor swivel arm (optional accessory). Please follow the corresponding instructions (4-hole assembly with a spacing of 4 4 inches (100 100 mm) according to the international VESA FDMI standard). Belinea 10 19 10 - Operating Instructions - 3 ENGLISH UNPACKING Power cord Carefully lift the monitor out of the packaging and make sure that all components are included (see fig. Save the original box and packing material in case you have to ship or transport the monitor. To set up the device, you must fit the monitor base together. Audio cable VGA cable MENU SELECT/AUTO DVI-D cable (optional) Figure 1. LCD Monitor CONNECTING To connect the monitor to your PC . . . . . . . . . . . . . . . . . . . . . . . . Make sure that the PC and monitor are unplugged. Connect the 15-pin signal cable to the monitor and the PC (see fig. The monitor is equipped with a DVI-D connector. If you have a graphic card with a digital DVI-D connector (24-pin socket), then connect one end of the DVI-D cable (optional) to the DVI-D connector of your monitor (see fig. 2b), the other end to the computer. DVI-D cable Figure 2b. Connection via the DVI-D interface Signal cable 2 1 Figure 2a. Connecting the monitor to the PC Figure 3. Connecting the monitor to the power source Connecting the audio cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In this case MAXDATA reserves the right to offer the customer several options on resolution in the form of a quotation and to charge the relevant processing costs. This also applies to those devices for which upon receipt, it is found that they are not covered by the warranty. In these cases, MAXDATA reserves ownership of the exchange device provided and is entitled to demand its return. MAXDATA reserves the right to charge costs incurred for unsuccessful attempts to collect a device that has been registered as defective from the customer. [. . . ]