User manual BELKIN F1DE101G

[. . . ] OmniView Remote IP Console TM Remotely control a server, or multiple servers with a KVM Switch, over TCP/IP networks User Manual ENTERPRISE Quad-Bus Series F1DE101G TABLE OF CONTENTS Overview Introduction . . . 1 . 1 . 2 . 3 . 4 . 5 Installation Hardware Installation . . 15 . 16 . 17 . 18 . 18 Security Ports & Protocols . . 25 Network Settings Menu Remote Access Settings . [. . . ] The e-mail address of a security contact person that is responsible for the RIPC. This is the length of the generated key in bits. 1024 bits are supposed to be sufficient for most cases. Larger keys may result in slower response time of the RIPC during connection establishment. Confirm Challenge Password E-mail Key length 25 SECURITY Certificate Request Required Information However, it is possible to generate and install a new certificate that is unique for a particular card. In order to do that, the RIPC is able to generate a new cryptographic key and the associated Certificate Signing Request that needs to be certified by a certification authority (CA). A certification authority verifies that you are who you claim you are and signs and issues a SSL certificate to you. The following steps are necessary to create and install the RIPC's SSL certificate: 1. Create a SSL Certificate Signing Request using the panel shown in the Figure below (Security Settings SSL Settings Create your own SSL certificate). Fill out a number of fields that are explained in the table above. Once this is done, click "Create CSR" which will initiate the Certificate Signing Request generation. The CSR can be downloaded to your administration machine with the "Download CSR" button (see Figure below). Send the saved CSR to a CA for certification. You will get the new certificate from the CA after a traditional authentication process. Upload the certificate to the RIPC using the Upload panel as shown in the Figure below. 26 SECURITY SSL Certificate Signing Request Note: If you destroy the CSR on the RIPC, there is no way to get it back!If you delete it by mistake, repeat the three steps. Settings & Configuration Network Network Settings Parameters Parameter IP address Subnet mask Gateway IP address 1. DNS Server IP Description IP address in the usual dot notation. IP address of the primary Domain Name Server in dot notation. This option may be left empty, however, the RIPC won't be able to perform name resolution. IP address of the secondary Domain Name Server in dot notation. It will be used in case the Primary DNS Server can't be contacted. If this option is enabled, access over the Power Management Unit is possible. [. . . ] Make sure the TCP port numbers 443 or 80 are open for incoming TCP connection establishments. No connection can be established to the RIPC. Check to ensure that the network connection is working in general (ping the IP address of the RIPC). Check whether the IP address of the RIPC and all other IP-related settings are correct. [. . . ]