User manual BELKIN F1UP0001

[. . . ] Wireless USB Print Server Share your USB printers wirelessly with your networked computers User Manual F1UP0001 TABLE OF CONTENTS Introduction . . 4 Connecting the Print Server Using the Setup Wizard . . 23 System Settings (Changing Password) . . 24 Printing to Multiple Print Servers . [. . . ] · Raw Printing: This feature allows clients to print to the Print Server using the standard TCP/IP printer port built into Windows XP and 2000 instead of the Belkin Port Monitor. Using Raw Printing requires the user to configure all port parameters manually and is not recommended for users unfamiliar with TCP/IP printing. · FTP Printing: This feature enables the printer to receive print jobs sent by FTP (see FTP Printing for detailed instructions). Disabling this feature will prevent FTP jobs. 22 WEB CONFIGURATION Web Interface ­ Upgrade Firmware This menu allows the user to upgrade the Print Server's firmware. Before running this application, download the new firmware from the Belkin website at www. belkin. com. Be careful to take note of the location of the downloaded file on your computer's hard disk. After downloading, click "Browse" on the screen shown below, select the file name of the downloaded firmware, then click "Apply Changes". The firmware upgrade will take a few minutes. NOTE: Do not interrupt the process by removing power from the Print Server or you could cause permanent damage to the device. 23 WEB CONFIGURATION Web Interface ­ System Settings (Changing Password) The Print Server ships with NO preset password. If you wish to set a password for greater security, be sure to choose a password that you will remember, and make a note of it. This utility will require you to enter the new password twice. If you are entering a password for the first time, leave the "current" password field blank. Press "Apply Changes" when done. The Web page auto-refresh interval setting can be changed in this menu. If you want a slower or faster interval, choose a number in the range and press "Apply Changes". 24 PRINTING TO MULTIPLE PRINT SERVERS If more than one Print Server is available on your network, and some computers need to be able to print to more than one Print Server, you will need to install the included Belkin Port Monitor (a virtual printer port) software on your PC. The Belkin Port Monitor can then be configured to select different Print Servers on your network to handle specific print jobs. Adding a Belkin Port Monitor and Configuring It for a Specific Print Server 1. In Windows, select the printer's properties and select the "Ports" tab. Click "Add Port". A window showing the printer ports installed on the PC will open. Select "Belkin Port" and, in the "Printer Ports" window, click "New Port". 25 PRINTING TO MULTIPLE PRINT SERVERS 3. In the "Enter New Port" window, enter a unique name for the port and click "OK". 4. Click "Close" on the "Printer Ports" window. [. . . ] If not installed and used in accordance with the instructions, it may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the distance between the equipment and the receiver. · Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Modifications The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by Belkin Corporation may void the users authority to operate the equipment. [. . . ]