User manual BELKIN F5C500

[. . . ] The ReSource® comes with Solid State Phone/Fax/Modem surge protection. Instead of running a connection directly from your Phone/Fax/Modem to the wall jack, you must pass the connection through the protected jacks on your ReSource®. Connect your phone/fax/modem line from your wall outlet to the "Input" jack on ReSource®. Connect the 6-foot phone cord provided with ReSource® into the "Output" jack, and connect the other end of the phone cord to the Phone/Fax/Modem jack of the device you want to protect. [. . . ] 5. trigger this circuit breaker and disconnect power. To restore power simply unplug one piece of equipment and push the circuit breaker button in. If not, consult the Amperage ratings on the connected devices and confirm that they do not exceed 15 amps total. Usually computers are 1-4 amps, fax machines 1-3, and most devices are below 2. You should not have a problem plugging in all your devices. 10Base-T Network Protection - Protects against surges coming through the network RJ45 line and damaging your computer. ReSource® will protect 10Base-T lines. Solid State Phone/Fax/Modem Protection - Maximum protection for your RJ11 line. ReSource® uses a solid-state-sidactor which provides maximum protection with twice the clamping speed of an MOV. Full Time Surge Suppression - ReSource® provides 1260 Joules of 3 line AC surge protection on all 8 outlets. Surge protection is always there, even if the main power is switched off. Instant Back-Up Power Supply - 4 outlets are labeled as back-up power supply. These outlets will receive 120 volts of power when battery is in use. Do not plug any devices into these outlets that are not critical when utility power is cut. The more devices powered by the battery, the shorter the back-up time. If possible, only plug your monitor and PC into these outlets and save the rest for emergencies. Troubleshooting Symptom ReSource® will not stay powered long enough to save and close. "Wiring OK" light is out. Cause 1. Too many devices plugged into instant battery back-up outlets. Outlet that ReSource® is plugged into is not properly grounded or has polarity crossed. The voltage in the building is bad, or there is a heavy load on the outlet ReSource® is connected to. Solution 1. Unplug unnecessary devices from battery back-up outlets. Try another outlet in the area, if results are the same, call an electrician to check the wiring of the building. [. . . ] To file a claim against the Belkin Connected Equipment Warranty, you must take the following steps: 1. Walnut St. , Compton CA 90220 Attn: Claims Dept. Be prepared to provide the following information: a. The part number of the Belkin Surge Suppressor. [. . . ]