User manual BELKIN F5D5230-4ENGLISHMACQUICK

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual BELKIN F5D5230-4ENGLISHMACQUICK. We hope that this BELKIN F5D5230-4ENGLISHMACQUICK user guide will be useful to you.

Lastmanuals help download the user guide BELKIN F5D5230-4ENGLISHMACQUICK.

Mode d'emploi BELKIN F5D5230-4ENGLISHMACQUICK

Download

Manual abstract: user guide BELKIN F5D5230-4ENGLISHMACQUICK

Detailed instructions for use are in the User's Guide.

 [. . . ] Select your connection type (this information is provided by your ISP) and click "Select". Depending on your selection,  you will see the "Static IP Address" page or the "PPPoE" page. Enter the required values provided by your ISP and click "Enter".  [. . . ] Connect each Mac to one of the ports on the rear of the Router labeled 1­4. Do not connect a computer to the port labeled "WAN". Connect a network cable between the Router and your cable or DSL modem. Be sure this cable is plugged into the port labeled "WAN" on the Router. 

BELKIN GATEWAY ROUTER

belkin. com Belkin Components
501 West Walnut Street Compton · CA · 90220 · USA 310. 898. 1100

Belkin Components,  Ltd. 
Unit 13 · Gatelodge Close · Round Spinney Northampton · Northants · NN3 8RX · United Kingdom +44 (0) 1604678300

Belkin Components,  Ltd. 
7 Bowen Cresent · West Gosford NSW 2250 · Australia +61 (2) 4372 8600

© 2001 Belkin Components. All trade names are registered trademarks of respective manufacturers listed. Mac is a registerd trademark of Apple Computer,  Inc. Connect the power adapter to the Router. After the cable or DSL modem and the Router are turned on,  the Router's WAN link light should be on. This indicates that the modem and the Router are connected to each other. After your computers boot up,  a LAN link light (on the front of the Router) will be on for each port to which a computer is connected. These lights are your means to verify that your computers are connected to the Router. You are now finished with dynamic IP configuration. Perform this operation for each computer that you will be connecting to the Router. 

Step 2: Configuring TCP/IP for dynamic IP configuration
Your computer will communicate with the Router through TCP/IP. To configure your Mac computer's TCP/IP settings to communicate with the Router,  follow the steps below.  [. . . ] At "Connect Via:",  choose either "Ethernet Built In" or "Ethernet" based on your Mac computer's interface. 

3. At "Configure:" choose "Using DHCP Server". This will tell the computer to obtain an IP address from the Router.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BELKIN F5D5230-4ENGLISHMACQUICK

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual BELKIN F5D5230-4ENGLISHMACQUICK will begin.