User manual BELKIN F5D6130

[. . . ] Wireless Network Access Point User Manual F5D6130 Table of Contents Introduction . 3 Knowing your Belkin Wireless Access Point . 8­10 Installing the Wireless Access Point Manager Software . 11­12 Using the Belkin Wireless Access Point Manager . [. . . ] Users of laptops need only to enter the passphrase and the key number into their computers' wireless management software to be able to communicate while using encryption. All computers on the network must use the same encryption rate and passphrase. The passphrase can be changed as often as desired. 18 Using the Belkin Wireless Access Point Manager Setting 64-bit Encryption 1. Select "Create with Passphrase". Enter a passphrase and click "Apply". Select the "Default Key ID" from the drop-down menu. 64-bit encryption is now enabled in the WAP. Each wireless-equipped computer (client) that needs to communicate with the WAP must be set to the same encryption settings. Select "Create with Passphrase". Enter a passphrase and click "Apply". 128-bit encryption is now enabled in the WAP. Each wireless-equipped computer (client) that needs to communicate with the WAP must be set to the same encryption settings. Using MAC Address Filtering 1. To set up the MAC filtering, click on "Command" and select "Set MAC Filter". 19 Using the Belkin Wireless Access Point Manager 2. The "MAC Address Filter" screen will appear. The WAP comes from the factory with the MAC Address Filter disabled. To enable the filtering, select "Enabled" from the drop-down menu. 3. In the field next to "<<Add", type in the MAC address of the adapter you want to add to the list. Click "<<Add". A total of 20 addresses can be entered into the WAP. To continue adding addresses, repeat Step 3 until finished. It is also possible to load a list of MAC addresses from a text file (. txt). Adding a List of MAC Addresses from a File 1. Select a . txt file from the browsing window and click "Open". [. . . ] In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8inches) during normal operation. Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. [. . . ]