User manual BELKIN F5D6130CE2

[. . . ] 8 Installing the Belkin Wireless USB Adapter Manager . 10 Using the Belkin Wireless USB Adapter Manager . 12 Installing the Belkin SOHO Networking Software for Windows 98/Me . 17 Configuring Your Windows 98/Me Computer Using Belkin NetSetup . [. . . ] BSS Displays the mode that the access point is operating in: Infrastructure or AD-Hoc To check the area for more access points, click "Re-Scan". To exit, click "Cancel ". 14 Using the Belkin Wireless USB Adapter Manager The Encryption Tab Select "64-bit" from the drop-down menu. You will notice when using 64-bit encryption there are four keys labeled "Key 1" through "Key 4". Keys can be entered manually, but for ease-of-use, the software can generate keys using a "passphrase" that you enter. This passphrase can be easily distributed to wireless-equipped computer users in your network. For instance, creating a key using the passphrase "Passphrase" generates four keys in 64-bit encryption mode and one key in 128-bit encryption mode. A user of a laptop needs only to enter the passphrase and the key number into their computer's wireless management software to be able to communicate while using encryption. All computers on the network must use the same encryption rate and passphrase. The passphrase can be changed as often as desired. Select "64-bit" from the drop-down menu. Select "Create with Passphrase". This will save some setup files to a disk, simplifying setup of subsequent computers. If you are not going to set up any more computers, click "No" and move to step 11. If you clicked "Yes", you will be prompted to insert a floppy disk into the PC's floppy disk drive. Label a floppy disk "Belkin Networking" and insert it into the floppy disk drive. After the client setup disk has been created, you will be prompted to restart your computer. Please restart your computer. 19 Installing the Belkin Wireless USB Adapter Manager Now that the first computer has been configured, we are ready to configure the other PCs on your network. You should now be working with the next computer. Click "Start", "Programs", "Belkin SOHO Networking", and then "Belkin NetSetup" to launch the easy-to-use computer configurator. Select "I am adding this computer to my network". Windows will now prompt you to insert the newly created client setup disk into the PC's floppy drive. Insert the disk you labeled "Belkin Networking" into the floppy drive and click "OK". [. . . ] Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Exposure to Radio Frequency Radiation. The radiated output power of this device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such manner that the potential for human contact normal operation is minimized. When connecting an external antenna to the device, the antenna shall be placed in such a manner to minimize the potential for human contact during normal operation. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8inches) during normal operation. Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]