User manual BELKIN F5D7000

[. . . ] 54g Wireless Desktop Network Card Share your broadband Internet connection and files belkin. com Belkin Corporation 501 West Walnut Street Compton · CA · 90220 · USA Tel: 310. 898. 1100 Fax: 310. 898. 1111 Belkin Components, Ltd. Express Business Park Shipton Way · Rushden · NN10 6GL United Kingdom Tel: +44 (0) 1933 35 2000 Fax: +44 (0) 1933 31 2000 Belkin Components B. V. Starparc Building · Boeing Avenue 333 1119 PH Schiphol-Rijk · The Netherlands Tel: +31 (0) 20 654 7300 Fax: +31 (0) 20 654 7349 Belkin, Ltd. 7 Bowen Crescent · West Gosford NSW 2250 · Australia Tel: +61 (0) 2 4372 8600 Fax: +61 (0) 2 4372 8603 Belkin Tech Support US: 310. 898. 1100 ext. 2263 Europe: 00 800 223 55 460 Australia: 1800 666 040 P74216 © 2003 Belkin Corporation. All trade names are registered trademarks of respective manufacturers listed. User Manual F5D7000 TABLE OF CONTENTS Introduction . . 11 Connecting to your Wireless Network . [. . . ] Select the "Data encryption (WEP enabled)" box. Clear the "The key is provided for me automatically" box. Type the network key in the "Network key" box. Note: You do not need to select the "Key format" or the "Key length" before typing the network key. These settings automatically change to the appropriate setting as you type the network key. Note: You must click on the "Apply" button before any changes take into effect. 20 21 USING THE BELKIN WIRELESS LAN UTILITY The Link Status Tab USING THE BELKIN WIRELESS LAN UTILITY (e) Channel Shows the current channel the Card is operating on. When operating in Infrastructure mode, the channel is set automatically by the access point or wireless router that the Card is connected to. You cannot change the channels in Infrastructure mode. In Ad-Hoc mode, the channel can be set manually. (f) Client IP Address Shows the IP address of the your wireless client. The IP address is obtained automatically by default. You may set the IP address manually through Windows Networking Properties. (g) Network Connection Type Shows the current wireless mode the Card is operating in. There are two operating modes: Infrastructure and Ad-Hoc. Infrastructure is the most common mode to operate in. Infrastructure mode is used when connecting your PC to a wireless access point or to a wireless router. Ad-Hoc mode is used to connect two or more computers together without the use of an access point or wireless router. (h) Radio State Shows whether the IP address of your wireless client is enabled or disabled. The IP address is obtained automatically by default. You may set the IP address manually through Windows Networking Properties. (i) Signal Strength Displays the strength of the wireless signal from 0 to 100%. The closer to 100%, the better the signal strength is. [. . . ] Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada. Europe-European Union Notice Radio products with the CE 0682 or CE alert marking comply with the R&TTE Directive (1995/5/EC) issued by the Commission of the European Community. Compliance with this directive implies conformity to the following European Norms (in brackets are the equivalent international standards). · EN 60950 (IEC60950) ­ Product Safety · EN 300 328 Technical requirement for radio equipment · ETS 300 826 General EMC requirements for radio equipment. To determine the type of transmitter, check the identification label on your Belkin product. [. . . ]