User manual BELKIN F5D7010CE1

[. . . ] CETECOM Inc. CETECOM Inc. 411 Dixon Landing Road, Milpitas, CA-95035, USA Phone: +1 408 586 6200 Fax: +1 408 586 6299 www. cetecom. com Issued test report consists of 33 Pages Page 1 (33) FCC LISTED, REG. [. . . ] Description Additional information Frequency Type of modulation Number of channels Antenna Power supply Output power Extreme temp. Tolerance 1. 6 : : : : : : : : : : : : : 2002-12-16 2002-11-21 2002-12-06/13 and 2003-01-02 See Applicant BCM94306CB 54g Wireless Lan cardbus PC card 2412MHz ­ 2472MHz DSSS / OFDM (orthognal frequency division multiplexing) 13 1dBi antenna From Host 16. 09dBm (40. 64mW) max. EIRP 0 to +70oC ETSI EN 300 328 V1. 4. 1 (2002-11) ETSI EN 300 328-2 V1. 2. 1 (2001-12) Test standards: Note: All radiated measurements were made in all three orthogonal planes. The values reported are the maximum values. CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 4 (33) 2 2. 1 Technical test Summary of test results No deviations from the technical specification(s) were ascertained in the course of the tests Performed Final Verdict: (only "passed" if all single measurements are "passed") Passed Technical responsibility for area of testing: 2003-01-10 Date EMC & Radio Section Lothar Schmidt (Manager) Name Signature Responsible for test report and project leader: 2003-01-10 EMC & Radio Date Section Harpreet Sidhu (EMC Engineer) Name Signature CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 5 (33) 2. 2 Test report TEST REPORT Test report no. : EMC_381EN328_2002 (BCM94306CB) CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 6 (33) TEST REPORT REFERENCE LIST OF MEASUREMENTS EFFECTIVE ISOTROPIC RADIATED POWER PEAK POWER DENSITY FREQUENCY RANGE SPURIOUS EMISSIONS RECEIVER SPURIOUS EMISSIONS PHOTOGRAPHS BLOCK DIAGRAMS CLAUSE 5. 2. 1 CLAUSE 5. 2. 2 CLAUSE 5. 2. 3 CLAUSE 5. 2. 4 CLAUSE 5. 3. 2 PAGE 7 9 13 16 24 28 29 32 TEST EQUIPMENT AND ANCILLARIES USED FOR TESTS Note: The clause numbers are referenced to ETSI EN 300 328 V1. 4. 1 (2002-11) CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 7 (33) EFFECTIVE ISOTROPIC RADIATED POWER CLAUSE 5. 2. 1 EIRP is calculated by method described under sub clause 7. 2. 1. 2, using following formulae; P = A + G + 10 log (1/x); Where; A = Average power (measured) Freq. (MHz) Average Power measured using wide band Power meter (dBm) 2412 2442 2472 13. 9 14. 4 14. 4 G = Antenna gain = 1dBi (Provided by Broadcom) x = Duty cycle = 0. 945 (measured) x = Txon / Txon + Txoff Txon Txon + Txoff x 10log(1/x) 2. 08msec 2. 2msec 0. 945 0. 24 Worst case variance (delts) at extreme temperatures from nominal power measured at 23ºC (Provided by Broadcom) Freq. (MHz) 2412 2442 2472 Delta in dB @ 0ºC +0. 01 +0. 45 +0. 21 Delta in dB @ +70ºC +0. 27 +0. 29 +0. 07 CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 8 (33) EFFECTIVE ISOTROPIC RADIATED POWER CLAUSE 5. 2. 1 TEST CONDITIONS TRANSMITTER POWER (dBm) EIRP Low frequency 2412MHz Mid frequency 2442MHz Pk 15. 64 Pk High frequency 2472MHz 15. 64 Tnom( 23 )0C Tmin( 0 )0C Tmax( +70 )0C Av ­ Average power during Burst Vnom (3. 3) Pk 15. 14 Vnom(3. 3) Vnom(3. 3) Pk 15. 15 Pk 16. 09 Pk 15. 85 Pk 15. 41 Pk 15. 93 Pk 15. 71 LIMITS: Under all test conditions CLAUSE 5. 2. 1 20dBm / -10dBW / 100mW CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 9 (33) PEAK POWER DENSITY For DSSS Systems CLAUSE 5. 2. 2 TEST CONDITIONS Peak Power Density (dBm/MHz) Low frequency 2412MHz Mid frequency 2442MHz 9. 35 High frequency 2472MHz 8. 22 Tnom( 23 )0C Vnom (3. 3) 8. 04 Under normal test conditions only -20dBW/MHz (10dBm/MHz) CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 10 (33) PEAK POWER DENSITY Lowest Channel: 2412MHz CLAUSE 5. 2. 2 Notes: -51. 96 dBm/Hz is added with 60dB to compensate for the dBm/MHz, therefore 8. 04dBm/MHz. CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 11 (33) PEAK POWER DENSITY Mid Channel: 2442MHz CLAUSE 5. 2. 2 Notes: -50. 57 dBm/Hz is added with 60dB to compensate for the dBm/MHz, therefore 9. 35dBm/MHz. CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 12 (33) PEAK POWER DENSITY Highest Channel: 2472MHz CLAUSE 5. 2. 2 Notes: -51. 78 dBm/Hz is added with 60dB to compensate for the dBm/MHz, therefore 8. 22dBm/MHz. CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 13 (33) FREQUENCY RANGE For DSSS Systems CLAUSE 5. 2. 3 FREQUENCY (MHz) at which ­80dBm/Hz occurs TEST CONDITIONS Low Frequency (fL) 2412 MHz Tnom( 23 )0C Tmin( 0 )0C Tmax( +70 )0C Vnom (3. 3) Vnom(3. 3) Vnom(3. 3) 2403MHz 2404MHz 2402MHz High Frequency (fH) 2472MHz 2481MHz 2480MHz 2482MHz LIMITS Under all test conditions fL > 2400 MHz CLAUSE 5. 2. 3 fH < 2483. 5 MHz CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 14 (33) FREQUECY RANGE Lowest Channel: 2412MHz Temp. :23 C Voltage:3. 3Vdc CLAUSE 5. 2. 3 CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 15 (33) FREQUECY RANGE Highest Channel: 2472MHz Temp. :23 C Voltage:3. 3Vdc CLAUSE 5. 2. 3 CETECOM Inc. Test report no. :EMC_381EN328-2002 Issue date:2003-01-10 Page 16 (33) SPURIOUS EMISSIONS (Radiated) Transmitter operating CLAUSE 5. 2. 4 NOTE: 1. Measurements were done on low & high channels, but plots depicting the worst case are submitted in the test report. The spurious emissions were done with different settings, using the relevant pre-amplifiers for the relevant frequency ranges. This is the reason that the graphs show different noise levels. [. . . ] This is the reason that the graphs show different noise levels. [. . . ]