User manual BELKIN F5U111

[. . . ] FCC-B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, the user will be responsible to correct the interference at his own expense. [. . . ] There are four main conditions to check: 1. You do not have a USB connection on the motherboard. The solution is to upgrade your motherboard or add a USB controller card. It is possible that you do have the proper OS, but there is no connection between the motherboard and the USB connectors on the bracket. It is possible that you do have the proper OS, but the controller on the motherboard is malfunctioning. The host computer might be in standby mode, and not supplying full power to its devices. The Ethernet Adapter did not properly enumerate. Enumerate is a USB term meaning the system has identified and configured the device and given it a unique address. The Ethernet port connection might be inoperable. Replace the Ethernet cable. The installation procedure produces the message: Hardware and software support for USB was not found. The LED is off. The LED is blinking. 10 2. Ethernet Adapter Package Dimensions: 4. 25 X 3. 75 X 1. 25 Connector (Ethernet): RJ45 Connector (USB): Series B Weight: 3. 9 oz. Power Requirements: 5 V, 200 mA (powered via the USB connection) Data Transfer Rate Can exceed 6 Mbits/s (depending on the computer, operating system, and communication protocol) Environmental Conditions Operating Range: 0 to 55 °C (32 to 131 °F) Storage Range: -20 to 80 °C (-4 to 176 °F) Humidity: 10 to 90%, non-condensing LED Flashes when the USB connection is operational. Remains steady on when both the USB and Ethernet connections are active. Memory Size 32K ( 8-bit SRAM for IN and OUT data buffers 1024-bit non-volatile configuration storage Certification FCC, Class B CE Mark Software Compatibility The Belkin Ethernet Adapter works with any standard Ethernet protocol. The supplied drivers for Microsoft Windows® 98 and Windows® 95 (OSR2. 1) support the following protocols: TCP, IPX, and NetBEUI. 3 USB Specifications 2. 2 Supplied Components The following components are included: · Belkin USB Ethernet Adapter device (Specifications are outlined in Section 7) · Belkin USB cable, 6' · Software installation diskette · Belkin USB Ethernet Adapter User Manual 2. 3 System Setup The USB cable is provided; you provide the network cable. Caution: If you choose to use a USB hub, the hub must be externally powered. In order to use the adapter, you must install drivers in the USB host PC, as described in the following sections. In addition, you need to configure the network parameters. You will need a network (Ethernet) cable, and your original Windows® 98 CD. 2. 4 Cable Connections Figure 2-1 illustrates the provided USB cable connection from the PC (A connector) to the adapter (B connector), and a standard 10Base-T Ethernet cable connection from the RJ45 connector on the adapter to an Ethernet port. When prompted in the installation procedure follow any of the following connections: 4 5. Uninstall than one network interface is installed). [. . . ] Select My Computer / Control Panel / Network. In this form, the USB Ethernet Adapter icon should be visible. If the TCP/IP protocol was previously installed, a network connection icon with the title TCP/IP -> USB Ethernet Adapter should also be visible. To specify the TCP/IP parameters, use the procedures described in section C below. [. . . ]