User manual BELKIN F5U217

[. . . ] Hi-Speed USB Pocket Hub User Manual P74081-A F5U217 TABLE OF CONTENTS Introduction . . 1 . 2 . 3 . 4 . 6 INTRODUCTION Congratulations and thank you for purchasing the Belkin Hi-Speed USB Pocket Hub (the Hub). [. . . ] Note: The Hub may be used without the power supply when connecting low-power devices such as keyboards and mice. Remove the USB A cable connector from its built-in storage bay, then plug it into the downstream port of your computer, or downstream port of another hub (see Fig. 1). Port 1 Upstream Port Figure 1 Port 3 Port 2 Important Note: The Hub must be connected to a USB 2. 0-compliant host in order to function in high-speed mode (480Mbps data rate). If the Hub is connected to a USB 1. 1-compliant host, it will operate only in low-speed or full-speed mode (1. 5Mbps/12Mbps). Your Windows operating system will now detect your Hub and install the required driver support. (The Windows 4 INSTALLATION "Install New Hardware Wizard" may prompt you to provide your Windows Installation CD to complete the driver installation process). Important Note: Hi-Speed USB hub drivers are included with most USB 2. 0 PCI upgrade cards, and are pre-installed along with the PCI card drivers. If you purchased an upgrade card prior to the release of Hi-Speed USB hub support, please check with your PCI card vendor for an updated USB 2. 0 driver. The Belkin Hi-Speed USB driver supports all competitive cards based on the NEC host controller with the exception of Adaptec. The most recent Belkin driver is available at www. belkin. com. Plug the USB A connector of the USB device, or an additional hub, into any of the downstream ports of the Hub (see Fig. 2). USB-A Connector Figure 2 Important Note: When plugging a USB device into the Hub for the first time, it may be necessary to reinstall the USB drivers for that device. Likewise, if you move the device to another port on the Hub, it may be necessary to reinstall the drivers. 5 INFORMATION FCC Statement DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITY We, Belkin Corporation, of 501 West Walnut Street, Compton CA 90220, declare under our sole responsibility that the product: F5U217 to which this declaration relates: Complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CE Declaration of Conformity We, Belkin Corporation, declare under our sole responsibility that the F5U217, to which this declaration relates, is in conformity with Generic Emissions Standard EN550022 1998 and with Generic Immunity Standard EN550024 1998, EN61000-3-2, and EN61000-3-3. Belkin Corporation Limited Lifetime Product Warranty Belkin Corporation warrants this product against defects in materials and workmanship for its lifetime. [. . . ] 2263 Europe: 00 800 223 55 460 Australia: 1800 666 040 © 2002 Belkin Corporation. All trade names are registered trademarks of respective manufacturers listed. P74081-A [. . . ]