User manual BELKIN F5U501FEU

[. . . ] Fasten the card securely using the screw that was used to hold the rear bracket. 6. Re-attach the case of your computer. 5 Installation (continued) 7. Re-attach all your peripherals to your computer, then power on your system. As Windows® 98 boots up, it will recognize the new FireWire® card in your system. [. . . ] Windows® will then ask you for the correct driver to use. Select the Texas Instruments driver as shown below, then click on "Next". NOTE: If Texas Instruments is not one of the choices, click on "Show all hardware". On the screen that appears, under manufactures, select Texas Instruments then under models, select Texas Instruments OHCI Compliant IEEE 1394 Host Controller. The screen that follows is an update warning prompt, click "Yes". 7 Installation (continued) 10. Windows® will then prompt you that it has found the driver file for your FireWire® card. At this point, Windows® may ask you for the Windows® 98 CD. Please be prepared to insert this into the CD-ROM drive of your computer if necessary. When Windows® is done copying and installing the proper driver files, it will show you the final dialog below. Click on "Finish" to end. 8 Installation (continued) That's it!Now you can enjoy all the benefits of super fast 400Mbps FireWire devices on your computer. After the Registration screen you will be prompted that setup is now complete. Before you click "Finish", make sure both boxes are checked. The next screens that will appear will show you a guided tour of MGI Video Wave III; afterwards you will gain access to Readme files which will give you more information about the MGI editing software. After you are done with the guided tour and Readme files, you will be asked to restart your computer. After restarting, connect your DV Digital camcorder to one of the slots on the 1394 FirePath card. Turn your camera "ON" before you start MGI Video Wave III SE. 10 Installation (continued) 10. After Launching Video Wave, click on the capture icon (see diagram below). Capture Icon 11. On the next screen that appears, click on the "Settings" button located on at the bottom right hand corner (refer to diagram below). Settings button 11 Installation (continued) 12. Under the "Capture Settings" screen set the Video Capture Device to "DVcam Capture", the Audio Capture Device to "DV Audio" then click "OK". 13. Once you are back on the "Capture Screen"(Video Wave Main screen), click the "Video+Audio" button to begin capturing. [. . . ] Once you are back on the "Capture Screen"(Video Wave Main screen), click the "Video+Audio" button to begin capturing. If you are in VideoWave and want to turn off the camcorder, you will need to exit VideoWave and then turn off the camcorder. Otherwise, VideoWave stops responding and you will need to exit VideoWave and restart the program to use it. Most camcorders shut down to save battery power when they are not used. [. . . ]