User manual BELKIN F6C1000-TW-RK

[. . . ] INTRODUCTION INSTALLATION Thank you for purchasing a Belkin Uninterruptible Power Supply (UPS). Each year, several natural and man made occurrences put the power supplied to your electronics in your home or office in jeopardy. At risk are your hardware, software and data because of these power problems. IMPORTANT SAFETY INSTRUCTIONS Note!Before installation, please inspect the UPS Upon receipt. [. . . ] This is normal and will not harm you or the UPS. 1). Connect the Network Protection Lines Connect the network line from the wall to the connector marked "IN", then connect the device (Ethernet card) to be protected to the connector marked "OUT". * All equipment must be turned off prior to hardware installation. SYSTEM REQUIREMENTS The UPS can be used without the software and can be used with any computer using a monitor or a flat panel screen. Also, you do not have to have the software installed to utilize the battery backup outlets. To fully utilize the UPS and its software, your computer must be able to operate the following operating systems: 95/ 98/ ME/ NT4/ 2000/ 2003/ XP & Linux & Higher and have a Serial or USB port. To fully utilize the Bulldog Plus Shutdown Software; you will need to connect the UPS to your computer. The communication port will provide the following features: 1. Monitoring battery status and condition 4. Use the ON/OFF/TEST UPS power switch function to schedule UPS for power saving SERIAL OR USB COMMUNICATION PORT (INSTALLATION OPTIONAL) Fig. 2 H_ ACCESSORY SLOT Optional SNMP Slot CONTENTS Fig. 4 for Model: F6C1000-TW-RK F6C1250-TW-RK You should have received the following: 1 ­ UPS unit 1 ­ Bulldog Plus Shutdown Software 1 ­ USB Cable 1 ­ Serial Cable 1 ­ Phone Line Cable You may connect the UPS to your computer by choosing either the Serial or USB ports. Do not connect your computer through both ports. Software Installation (Installation Optional) To fully utilize the UPS and its software, your computer must be able to operate the following operating systems: Windows98/ ME/ NT4/ 2000 / 2003/ XP and have a USB port. TECHNICAL SPECIFICATIONS MODEL Capacity INPUT Voltage Range Frequency Voltage OUTPUT Frequency (On battery) Back up time 50%~100% load Typical Recharge Time F6C1000TW-RK F6C1250TW-RK F6C1500TW-RK A) 1000VA/ 615W 1250VA/ 680W 88-140Vac 60HZ ( ±3HZ ) 1500VA/ 830W Your UPS features the Bulldog Plus Shutdown Software. This allows you to protect and save your data should a power outage occur, as well as safely shutdown your computer in your absence. Please be sure to close out of all applications prior to installing the software. To install the software, please place the CD into the CD drive of your computer. If this does not occur, go to the Run feature on your Start icon (lower left corner) on your screen. Please enter the CD drive, it may be D: Upon entering the drive run setup. exe. Should you continue to have a problem, please refer to your computer's owner's manual for the correct drive. The "Welcome to the Belkin Bulldog Plus Product Installation Browser" will appear. Please click Install and select the Windows version. The Bulldog Plus Installation window will appear. [. . . ] Furthermore, no warranty or guarantee is made regarding the use or results of the product, software, program, documentation, or any related information, goods or services in terms of correctness, accuracy, reliability, timeliness or otherwise. You use and rely on the program at your own risk. The following is the only and exclusive warranty and remedy of any kind: Belkin does warrant that the program disks are free from physical defects Away from sunlight Away from heat Away from BELKIN COMPONENTS USER LICENSE AGREEMENT water in materials and workmanship under normal use for a period of one (1) year from the date of purchase, as evidenced by a copy of the sales receipt. Return the defective disk or documentation with your receipt directly to Belkin for a replacement. [. . . ]