User manual BELKIN F6HXXX-USB-C

[. . . ] R F6H350-USB F6H500-USB F6H650-USB ALARMS Back Up (Slow Alarm) When in "BACK UP" on battery mode, the RED LED illuminates and the UPS sounds an audible alarm. The alarm stops when the UPS returns to LINE NORMAL operation. Low Battery (Rapid Alarm) In "BACK UP" mode, when the battery energy runs low, the UPS beeps rapidly until the UPS shuts from a depleted battery or returns to LINE NORMAL operation. Fault (10 Seconds Continuously) When the output is shorted, the UPS emits a 10 seconds continuously alarm to warn of a short condition. [. . . ] The Site Wiring fault LED can indicate 1 of 2 possible conditions: 1. Open or high resistance on the ground line 2. Hot or neutral polarity circuit *Note in order for your UPS to work properly, you must have a properly grounded AC circuit. If your Site Wiring Fault LED is lit, please contact an electrician to properly wire this circuit. 5. 2 Communication port (Optional) To fully utilize the Sentry Bulldog Shutdown Software; you will need to connect the UPS to your computer. Connect the USB cable to your UPS then connect the other end to the USB port on your computer. Software Installation (Optional) Compatible with any computer running the following: 95/98/ME/NT4/2000/XP & Novell 3. X & Higher 1. Your UPS features the Sentry Bulldog Shutdown Software. This allows you to protect and save your data should a power outage occur, as well as safely shutdown your computer in your absence. This software is compatible with Windows 95/98/ME/NT4/2000/XP and Novell 3. X & higher. To install the software, please place the CD into the CD drive of your computer. Your computer should automatically run (AutoPlay) the CD. If this does not occur, go to the Run feature on your Start icon (lower left corner) on your screen. Please enter the CD drive, it may be D: Should you continue to have a problem, please refer to your computer's owner's manual for the correct drive. Once uploaded, please click the Bulldog icon on the screen. Click Install Belkin Sentry Bulldog for Win 95/98/ME/NT4/2000/XP InstallShield Wizard will appear onscreen, click Next. Please read the License Agreement and click Yes. You should not install the networking files unless you are technically qualified to use these features. For more information on networking, please refer to the software user's manual. The software user's manual can be downloaded from the user's manual icon. Diagram 2 AC Input Power Cord (See #1 on Diagram 2) Provides power to your UPS. Phone/ Fax/ Modem Surge Protection (See #2 on Diagram 2) The Phone/ Fax/Modem lines are surge protected. There is one input jack and two output jacks. [. . . ] You agree that upon such termination you will immediately destroy all programs and documentation, including all copies made or obtained by you. SOFTWARE, PROGRAM, DOCUMENTATION, AND ANY RELATED INFORMATION, GOODS OR SERVICES ARE PROVIDED WITH NO WARRANTY OR REPRESENTATION OF ANY KIND WHAT SO EVER. BELKIN HEREBY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The entire risk of the use, results and performance of the software, program and documentation is borne by you. [. . . ]