User manual BELKIN F8V9017

[. . . ] Only use the Headset when and where it is safe to do so. Operation in Special Environments · Medical equipment and hospitals: Due to the risk of interference with medical equipment, do not use the Headset or a mobile phone nearby without permission. · Aircraft: To avoid interference with communication systems, turn the Headset OFF when required to do so by airline regulations. · If you are unsure if radio-transmitting equipment is allowed in any area, seek authorization before turning the Headset ON. [. . . ] · The ear hook can be replaced either way up. Note the indentation in the center to properly orient the ear hook on the Headset. · With the user controls facing the user and the LED at the top, the closed loop of the ear hook should "point" right for operation on the right ear, and left for the left ear. · To place on the ear, hold the Headset in the hand and push the open end of the hook slightly away from the Headset body. 12 Operation (continued) · Slide the open end of the ear hook onto the ear from the front. It will tend to lock in position with a slight twisting motion. · The ear hook is malleable for further slight adjustment. Press the main button until a short tone is heard in the earpiece. The Headset will generate the switch-on melody in the earpiece. The LED will flash the signal to indicate the Headset is now in STANDBY mode ready to be paired, or if already paired, ready to make or receive a call. Press the main button until a short tone is heard in the earpiece. The Headset will generate the switch-off melody. The LED will stop flashing. 13 Operation (continued) Preparing the Headset for Use--Pairing PIN Code: The PIN code for the Headset is preset to 1234. Before the Headset can communicate, it must be paired to the companion device it will be used with, such as a mobile phone. This is to ensure the Headset only communicates with the device chosen by the user and not any other Bluetooth devices in range. Pairing information is stored by the Headset and can be changed at any time. The exact process to pair the Headset will also depend on the device it is paired with. The user manual for that device will give instructions on how to do this. In all cases, the Headset will need to be put into PAIRING mode, which is described here: 1. When the short tone is heard, keep the button pressed until the pairing melody is generated. 14 Operation (continued) 4. The LED will alternately flash red/green. Follow instructions for the companion device to pair to the Headset. When prompted on the companion device, enter the PIN code for the Headset. [. . . ] · If the Headset is in any other mode when connected to the charger, the LED flashing sequence does not change, but the LED color will indicate the charge status. 17 Operation (continued) · Sometimes, when the Headset is placed on charge with the LED still showing a green color, the LED color may change initially from green to red. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment. Canada- Industry Canada (IC) The wireless radio of this device complies with RSS 139 & RSS 210 Industry Canada. [. . . ]