User manual BELKIN HI-SPEED USB 2.0 EXTERNAL DRIVE ENCLOSURE

[. . . ] Hook the first side rail around the front edge of the External Drive and press the rail into the six rectangular-shaped mounting holes on the side. If you are installing a hard disk, it is necessary to install the front panel. Insert the tabs on one side of the front panel into the mounting holes in the installed side rail. Insert the mounting tabs on the free end of the front panel into the second side rail, and hook the side rail onto the front of the External Drive. [. . . ] When the system prompts "You may safely remove this device", unplug the USB cable from the USB port of your computer. 0 External Drive that you want to disconnect, then click on "Stop" again. When the system prompts "You may safely remove this device", unplug the USB cable from the USB port of your computer. There are two methods to partition and format your USB 2. Your new hard disk will appear in the hard drive list (in this case as "Toshiba 1924FCV"). Make sure there are check marks in the "Disconnect", "Sync Data Transfer", "Removable", and "Int 13 unit" boxes. After making these changes, it will be necessary to restart your computer. Your removable hard drive is now ready for use. Note: Using this method to format your removable hard drive will result in a single partition equal in size to the maximum rated capacity of your hard disk. Note: If the FDISK utility terminates without displaying an error message, exit back to Windows and disconnect the External Drive. When Windows restarts, reconnect the External Drive and go back to Step 1. In the opening FDISK screen, answer the question: "Do you want to enable large disk support?" Enter "Y" if you want to create a partition larger than 2GB. Enter "N" if you want to create a partition smaller than 2GB. Select your new disk from the list of available drives. In the "Change Current Fixed Disk Drive" screen, enter the disk drive number that is assigned to your External Drive. Be sure that you select option 5 and change the "Current Fixed Disk" from "Disk 1" to the disk number assigned to your External Drive. If your computer is equipped with only one internal drive, your new External Drive will be identified as "Disk 2". If your computer is equipped with two internal disk drives, your new External Drive will be identified as "Disk 3". Failure to follow this step will result in the loss of all data on your primary internal hard disk. [. . . ] We, Belkin Corporation, of 501 West Walnut Street, Compton, CA 90220, declare under our sole responsibility that the product: F5U209 to which this declaration relates: Complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. We, Belkin Corporation, declare under our sole responsibility that the F5U209, to which this declaration relates, is in conformity with Generic Emissions Standard EN55022 1998 and with Generic Immunity Standard EN55024 1998, LVD61000-2-3, and LVD61000-3-3. Belkin Corporation warrants this product against defects in materials and workmanship for its lifetime. [. . . ]