User manual BELKIN WIRELESS OPTICAL USB MOUSE

[. . . ] Works with all PCs that are compatible with IBM® and equipped with USB interface NOTE: Use of these products on a desk made of iron, or other metal, will negatively impact the operation of your Wireless Mouse. Wireless Optical Mouse Receiver 2 AA batteries User Manual Please read the instructions for installing, operating, and using the wireless mouse. Be sure that your computer is turned on. If you are running Windows 98 SE, Me, or 2000, you will need to keep your old mouse connected for installation. [. . . ] Make sure you have properly established communication/ synchronization between the receiver and the Mouse: 1) Press the reset button on the receiver. If the Mouse is not working, make sure that the LED on the Mouse starts flashing when you push any of the Mouse buttons, or move the Mouse. If the LED does not flash, check to make sure you have installed the batteries correctly. When the Mouse LED is flashing, the LED on the receiver should also flash to indicate they are speaking to each other. If the LED on the receiver does not flash, it means that the device has not connected properly. If your Mouse pointer becomes choppy on-screen, replace batteries with a fresh set. We, Belkin Corporation, of 501 West Walnut Street, Compton, CA 90220, declare under our sole responsibility that the product, F8E847eaUSB to which this declaration relates, complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. We, Belkin Corporation, declare under our sole responsibility, that the F8E847eaUSB to which this declaration relates, is in conformity with EN55022, EN61000-3-2, EN61000-3-3, and EN55024. The radiated output power of this device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such manner that the potential for human contact normal operation is minimized. When connecting an external antenna to the device, the antenna shall be placed in such a manner to minimize the potential for human contact during normal operation. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8inches) during normal operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: · Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by Belkin Components may void the users authority to operate the equipment. [. . . ] Compliance with this directive implies conformity to the following European Norms (in brackets are the equivalent international standards). Products with the CE marking comply with the EMC Directive (89/336/EEC) and the Low Voltage Directive (72/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms (in brackets are the equivalent international standards). EN 60950 (IEC60950) ­ Product Safety Products that contain the radio transmitter are labeled with CE 0560 or CE alert marking and may also carry the CE logo. [. . . ]