User manual BELL AUDIO PSX6200A

[. . . ] Channel fader should be down, when operating phantom power switch. When using only dynamic microphones, phantom power should be in 'OFF' position. Line Input Jack Sockets (mono channels 1-6) These channels are for use with monaural line signals such as musical instruments. (Line input amplification is 22dB below the GAIN setting). [. . . ] (Line input amplification is 22dB below the GAIN setting). Stereo Input channels 7/8 and 9/10 Via Jack Sockets L/R, these channels may be used either as mono- or stereo channels. (Selector switch in position A) The RCA inputs L/R are for use with stereo line signals only and will be activated by setting the selector switch to position B) HPF (High Pass Filter) Channels 1-6 feature a High Pass Filter which will help to dampen resonances below 100Hz (-12dB/oct. ) HPF should be used with vocal microphones etc. Turn TRIM control slowly clockwise and use microphone / Instrument at normal singing / playing volume. AUX1/MON works 'pre fader' (independent from the Channel faders) AUX2/EFF (post fader) Combined AUX/EFF Control. sends the channel signal to the built-in multieffect unit and to the AUX2 Send socket. AUX2/EFF works post fader (fades up and down with the channel faders) PAN (Mono Input Channels 1-6 only) Determines the position of the signal within the final stereo mix. Setting PAN fully CCW will send the signal only to the left mixing bus. setting PAN fully CW will send the signal only to the right mixing bus. PHONES Use any dynamic headphone with 1/4" stereo pone jackplug. The POWER ROUTING switches enable the use of the two internal power amplifiers via the L&R MASTER Faders (NORMAL SETTING) or the MONITOR Fader. Master Mode Connect the main loudspeakers for L&R (front/foh) with speakon type connectors to the speaker out sockets L&R at the rear panel. Monitor Mode Enables the use of the internal power amplifiers to drive your stage monitor loudspeakers. In this mode, the selector switches will be set to , MON` position and the internal power amplifiers will receive signals from the MONITOR bus via the MONITOR Fader. Your main loudspeakers (L&R) can now be powered by a separate power amplifier (for example BELL PSX or CS series) which will be connected to the L-OUT and R-OUT sockets. Use to connect external power amplifiers (BELL PSX or CS), when the internal power amplifiers are driven in Monitor mode. Use to connect external power amplifiers etc. Use to connect external monitor power amplifiers or active monitor loudspeakers. aUX1 Send , AUX2 Send Jack Socket outputs. [. . . ] Use to connect external monitor power amplifiers or active monitor loudspeakers. aUX1 Send , AUX2 Send Jack Socket outputs. Use to connect external effect units (Send) via the AUX1 / AUX2 master controls. Use of these sockets cuts connection to Master outputs. [. . . ]