User manual BELSON BP2003

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] Check whether there is any detergent residue on the edges of the dispenser. It is due to this residue that the lid won't close. Get rid of it and you'll see that it closes. • Keep your dishwasher detergent and rinse aid in a cool, dry place and away from children. This product makes dishes sparkle more as it improves their drying. The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes. To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. You can choose from six different positions. Proper dosage of the rinse aid improves drying. The precaution is not taken, the water dishwasher is provided with water inlet could get blocked, causing supply and drain hoses, which can damage to your dishwasher. Your dishwasher can be supplied with hot water from the mains Levelling. Supply (if you have a central heating Once the appliance is positioned, system with radiators) at a tempeadjust the feet by screwing them rature of no more than 60°C. In or out depending on how high In this case, the wash cycle time you want it and to level it so that it will be about 15 minutes shorter is horizontal. Make sure that it is and the wash will be slightly less not inclined more than 2 degrees. If the appliance is level, it will help The connection must be made to ensure its correct operation. Hot water supply following the same procedures as those indicated Adjusting the back Feet for the cold water connection. Insert the appliance into the cutout A and then adjust the height using the Anti-flooding protection screws located on the front bottom Your dishwasher is provided with a part of the machine. Use a special system which blocks the screwdriver to turn the screws in water supply in the event of leaks the clockwise or anti-clockwise inside the appliance. It is further direction to increase or decrease equipped with a water inlet hose the height respectively. That can withstand extremely high pressures and that turns bright red Cold water connection. [. . . ] Check the sprayer arms regularly and clean them once in a while (letters F and I “How is it made?C Keep your dishwasher in shape Respecting these few rules ensures you will always have a reliable work companion by your side. When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. [. . . ]