User manual BELSON BP8410

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 12) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. D You can choose from six different positions. Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. Warning Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one. If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the formation of white streaks on your dishes or on the interior of the appliance. Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container. If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no. How to look after and protect the dishes you hold dear s Almost all silverware can be cleaned in a dishwasher. There are two exceptions: old silverware and silverware decorated with an oxidising agent. to facilitate appropriate Your dishwasher can be supplied installation. With hot water from the mains This dishwasher model can be supply (if you have a central heating built under a single worktop system with radiators) at a tempe(please read the relevant rature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter Levelling. And the wash will be slightly less Once the appliance is effective. Positioned, adjust the feet by The connection must be made to screwing them in or out hot water supply following the depending on how high you same procedures as those indicated want it and to level it so that it for the cold water connection. Make sure that it is not inclined more than 2 Drain hose connection. If the appliance is Fit the drain pipe into a drain line level, it will help ensure its with a minimum diameter of 4 cm Electrical connection. Special plastic elbow provided (see correspond to those stated on the This electric household figure) to position it in the best rating plate located on the stainless appliance should be connected possible way. The part of the pipe steel inner door of the appliance to the water mains using the marked with the letter A should be and that the electrical system to cold water supply hose between 40 and 100 cm above the which the dishwasher is connected provided with the appliance ground. [. . . ] C Keep your dishwasher in shape Respecting these few rules ensures you will always have a reliable work companion by your side. When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. [. . . ]