User manual BELSON CM1359

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] The rinse aid container is situated on the inside of the door. You should fill it up on average every 80 wash cycles (if your dishwasher is provided with the "low rinse aid" indicator light, then fill it up when it comes on). To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. c Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. You can choose from six different positions. 16 ARISTON DISHWASHER - Instructions for installation and use D ISHWASHER Select the right wash cycle A wash cycle for every degree of soil Salt, rinse aid, the right amount of detergent and the correct wash cycle: this is the formula to get the best results and to keep your dishwasher in shape Select the right wash cycle for your dishes. Selecting the most suitable wash cycle for the load ensures clean dishes and a more convenient use of water and electricity. Ask the company that supplies water in your area. Savings are easy How to look after and protect the dishes you hold dear Using your electric household appliances wisely helps you make savings and is good for the environment. To optimise consumption levels, try to use the dishwasher with a full load only. If it takes quite some time to fill up your dishwasher, use the soak cycle to avoid the formation of bad odours and caked-on food. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. Make sure that it is not inclined more than 2 degrees. If the appliance is level, it will he lp ensure its correct operation. Connect the cold water supply hose to a threaded 3/4 (gas) connector, inserting the small filter supplied with the dishwasher and making sure that it is fastened tightly in place (see figure 2). If the water hoses are new or have been out of use for an extended period of time, let the water run to make sure it is clear and free of impurities before making the connection. If this precaution is not taken, the water inlet could get blocked, causing damage to your dishwasher. If the power socket to which the appliance is connected is not compatible with the plug, replace it with a suitable plug rather than using adapters or multiple plugs as these could cause overheating or burns. [. . . ] Keep your dishwasher in shape Respecting these few rules ensures you will always have a reliable work companion by your side. When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. [. . . ]