User manual BEMIS 736200

[. . . ] 8 Product and Cut-out Dimensions Installation 1. Install the dishwasher under the countertop . Secure the dishwasher to adjacent cabinetry . 31 2 IMPORTANT SAFETY INSTRUCTIONS Installation Installation, maintenance and repair work should be by a Miele authorized service technician. [. . . ] This will allow the machine to slide easier, protect the floor, and allow adjustment of the rear leveling legs from the front of the unit. ^ First, adjust the height of the legs so that the top of the dishwasher is roughly 1/8" (3 mm) below the countertop. Tipping the machine slightly to the rear, if possible, will make adjusting the front legs easier. Make sure the machine is level when adjustments are complete. ^ Place the skis, with the ratchet at the rear, under the dishwasher legs. 13 Installation 3. Install the dishwasher under the countertop The dishwasher must be installed so that the water and electricity supplies can be accessed through an adjacent cabinet. The supplies must not be located behind the machine. ^ Make certain that there are no rough edges that could damage the power cord or hoses. If metal cabinets are used, place the supplied rubber grommet around the edge of the opening before passing the cable through. , WARNING - Fire hazard Do not cover or crush the plug of an electric appliance. Ensure that the cabinet opening for the dishwasher provides ample space for the plug. Installing the dishwasher in a tight space may crimp the power cord or put pressure on the plug which may cause overheating. The floor of the cut out where the dishwasher will be installed should be even in height with the surrounding kitchen floor. Plywood can be secured to the floor to make the two areas even. ^ Slide the machine into the opening, making sure the electrical cable and hoses can reach their connection points without kinking. ^ Once this side of the panel lines up with the cabinets, secure it by tightening the upper screw on the edge of the dishwasher door. ^ Repeat the process with the other side of the panel. Insert the supplied end caps into the four screw holes. Adjust one side of the door panel at a time using a T20 Torx screwdriver. Do not use a power screwdriver to adjust or secure the decorative panel to the dishwasher. ^ If the upper screws on the edge of the door are not loose, loosen them slightly. ^ The panel can be raised or lowered by turning the lower screw on each side of the dishwasher door. To lower the panel turn counterclockwise. 21 Installation 7. Secure the dishwasher to adjacent cabinetry Only for openings exactly 17 3/4" (45 cm) wide: , The side mounting holes should only be used for securing the dishwasher if the opening is exactly 17 3/4" (45 cm) wide. Using this method on larger openings may damage the machine and cause leaks. ^ Open the dishwasher door and remove the caps covering the mounting holes on the outer edge of the wash cabinet. ^ Secure the dishwasher to the adjacent cabinets using the supplied screws and bushings. Make sure a bushing is placed over the screw before inserting it into its mounting hole. [. . . ] Pass the permanent power supply cable through the strain relief and secure it to the terminal box. Connect: L1 N (Black) to L on terminal block (White) to N on terminal block GRND To ground connector GROUNDING INSTRUCTIONS This appliance must be connected to a grounded metal, permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead on the appliance. Use copper conductors only. should only be done if required by local electrical codes, and then in accordance with those codes. Do not cut the plug off the power supply cord and connect it directly to the house wiring. , Hardwiring the dishwasher 29 Installation 11. Test the unit Once the dishwasher is level and secured it should be tested. [. . . ]