User manual BENDIX MC-30 TRAILER ABS CONTROLLER

[. . . ] Bendix® MC-30TM Trailer ABS Controller Assembly LED Diagnostic Display 30-Pin Connector ABS Modulator Connector (MOD1) Control Port 1/4" NPT Delivery Ports 3/8" NPT (x4) TABLE OF CONTENTS PAGE Components . . 2 MC-30TM Controller Comparison to MC-12TM Modulator. . 6 MC-30TM Controller Power-up Sequence . 11 MC-30TM Controller Diagnostic Display . [. . . ] It can also be used to diagnose the EC-15TM, EC-16TM, EC-17TM and EC-30TM tractor ABS controller units. For more information on the Bendix diagnostic cartridge from MPSI, contact Bendix or refer to your local authorized Bendix dealer. ® CORRECT MAINTENANCE PRACTICES WARNING!PLEASE READ AND FOLLOW THESE INSTRUCTIONS TO AVOID PERSONAL INJURY OR DEATH: When working on or around a vehicle, the following general precautions should be observed at all times. Park the vehicle on a level surface, apply the parking brakes, and always block the wheels. Stop the engine and remove ignition key when working under or around the vehicle. When working in the engine compartment, the engine should be shut off and the ignition key should be removed. Where circumstances require that the engine be in operation, EXTREME CAUTION should be used to prevent personal injury resulting from contact with moving, rotating, leaking, heated or electrically charged components. Do not attempt to install, remove, disassemble or assemble a component until you have read and thoroughly understand the recommended procedures. Use only the proper tools and observe all precautions pertaining to use of those tools. If the work is being performed on the vehicle's air brake system, or any auxiliary pressurized air systems, make certain to drain the air pressure from all reservoirs before beginning ANY work on the vehicle. If the vehicle is equipped with an AD-IS® air dryer system or a dryer reservoir module, be sure to drain the purge reservoir. Following the vehicle manufacturer's recommended procedures, deactivate the electrical system in a manner that safely removes all electrical power from the vehicle. Never exceed manufacturer's recommended pressures. Never connect or disconnect a hose or line containing pressure; it may whip. Never remove a component or plug unless you are certain all system pressure has been depleted. Use only genuine Bendix® replacement parts, components and kits. Replacement hardware, PLC DIAGNOSTIC TOOL Diagnostic tools are available that detect the presence of a PLC signal and perform further system diagnostics directly on the power line. For more information on these diagnostic tools, contact Bendix or refer to your local authorized Bendix dealer. CONTACTING BENDIX - www. Bendix. com The Bendix on-line troubleshooting guide for the MC-30TM controller will help you determine the cause of any conditions that may be preventing 100% performance of your braking system. For additional troubleshooting information on the MC-30TM controller, please refer to our literature request section. The Bendix on-line contacts guide will make it easy for you to find the Bendix contacts you need. From this page, you can navigate to technical support contacts, service engineers, Bendix account managers, international contacts and more. Bendix. com is your complete Bendix resource. Bendix Technical Assistance Team: For direct personal technical support, call the Bendix technical assistance team at 1-800-AIR-BRAKE (1-800-247-2725), Monday through Friday, 8:00 A. M. [. . . ] Reconnect all connectors to the MC-30TM controller and M-30TTM modulator-valve. Reset fault codes by briefly holding a magnet in place at the RESET location of the diagnostic display. Go to Section A. YES Static ABS Modulator Faults Verify 7. 0 to 10. 0 OHMS across Hold and Common connector pins. Verify 7. 0 to 10. 0 OHMS across Exhaust/ Common connector pins. [. . . ]