User manual BENQ DC2410 annexe 2

[. . . ] DC 2410 User's Manual Copyright Copyright (c) 2003 by BenQ Corporation. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without prior written permission from BenQ Corporation. Brands and product names are trademarks or registered trademarks of their respective companies. Disclaimer BenQ makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. BenQ assumes no responsibility for any error that may appear in this document. [. . . ] Recording Mode Please set the Mode Dial at Recording Mode ( the below functions. Set Up Focus Range Before you take pictures, please make sure you set the Focus Switch at the correct focus range or the image may not be clear. Turn On or Turn Off the LCD Display (Preset at On status) You can change the icon display on the TFT LCD Monitor, turn it off, and turn it on again by pressing the LCD button in order. III. Set Up Flash Mode (Preset at Auto Flash mode) You can change the flash mode shown below according to the environment. There are five flash modes as below: a. Auto flash( ): The camera will judge the necessity of using the flash. If the environment is too dark the flash will fire automatically. 7 BenQ DC 2410 User's Manual b. Auto flash with red-eye reduction( ): The camera will judge the necessity of using the flash and reduce the chance of red-eye reduction. Slow sync ( ): The shutter speed will become slow in order to catch more light to make good images in low light circumstances. Under this mode, it is suggested to use a tripod to make sure the camera is held still while taking the picture. Fill-in-flash( ): The flash will fire in any light circumstances. Flash off ( ): The flash will not fire in any light circumstances. IV. Set Up Self-timer (Preset at no self-timer) The self-timer starts with the countdown for 10 seconds. The self-timer will be automatically cancelled once the shoot is done. V. Set Up Digital Zoom (Preset at no digital zoom) The zoom bar, appearing on the left on the TFT LCD monitor, shows the current digital zoom position. Note It is normal that the image with digital zoom is not as sharp comparing to the image without digital zoom. 8 BenQ DC 2410 User's Manual VI. Set Up Image Size (Preset at 1600 x 1200) Step Step : To enter the setting mode. Step : To select and enter the option. : To escape the setting. : To select and confirm the option. Step Four resolutions provided can be selected as follows: ( ) 2560 x 1920 (XL) ( ( ( ) 2048 x 1536 (L) ) 1600 x 1200 (M) ) 1280 x 960 (S) Note You can easily check whether the setting is changed or not by the resolution icon display on the right side of the LCD screen. If not, please repeat the above steps. 9 BenQ DC 2410 User's Manual VII. Set Up Image Quality (Preset at Fine quality) Step Step : To enter the setting mode. : To select and confirm the option. Step Step : To select and enter the option. : To escape the setting. Three levels of image quality can be selected as follows: ( ) Super Fine ( ( ) Fine ) Normal Note The better the image quality is set, the less number of images can be stored in the builtin flash memory or the memory card. 10 BenQ DC 2410 User's Manual VIII. Set Up Voice Memo (Preset at 10 SEC) Step Step : To enter the setting mode. Step : To select and enter the option. [. . . ] View the image with double-clicks. 27 BenQ DC 2410 User's Manual 5. TROUBLESHOOTING (ERROR MESSAGE TABLE) Message CARD FULL Cause There is insuffient card memory capacity to store an image. There is insuffient internal memory capacity to store an image. The image can't be deleted under protection. [. . . ]