User manual BENTEL SECURITY J408 INSTALLATION

[. . . ] CONVENTIONAL F I R E PA N E L S 424 408 INSTALLATION MANUAL ® This Control panel can be programmed using the respective Software J400 release 1. 0 or higher. BENTEL SECURITYsrl shall not assume the responsibility for damage arising from improper application or use. This Control panel has been designed and manufactured to the highest standards of quality and performance. Installation of this Control panel must be carried out strictly in accordance with the instructions described in this manual, and in compliance with the local laws and bylaws in force The J424 and J408 Control panels comply with the essential requirements of standards EN54-2; EN54-4. [. . . ] MODE NAC OUTPUT NAC1 FAULT NAC1 RESTORE NAC2 FAULT NAC2 RESTORE OUT 1 RESTORE OUT 1 SHORT OUT 2 RESTORE OUT 2 SHORT OUTS BYPASSED OUTS UNBYPASSED PE OUT ACTIVATED PE OUT FAULT PERIPHERAL FAULT PERIPHERAL REST. PERIPHERAL REST. EVENTS DETAILS None None None None Zone no. None None Enabled/Disabled Extinguishment Mod. Night/Day Enabled/Disabled None None None None Power Supply Stat. Device type+Number DESCRIPTION 24R output shorted 24R output previously shorted 24V output shorted 24V output previously shorted Zone no. is in Alarm status Automatic Extinguishment of Extinguishment Mod. re-enabled Charger of Power Supply Stat. not operating properly Charger of Power Supply Stat. previously not working Batteries of Power Supply Stat. disconnected Panel batteries empty, malfunctioning or disconnected Batteries of Power Supply Stat. empty or disconnected Batteries of Power Supply Stat. previously disconnected Batteries of Power Supply Stat. nr previously low Panel batteries previously empty, malfunctioning or disconnected Batteries of Power Supply Stat. empty or disconnected Buzzer disabled Zone no. disabled A detector connected to zone no. is missing Dialler Output active Automatic Extinguishment of Extinguishment Mod. nr. i disabled Dialler connections interrupted or shorted Dialler connections interrupted or shorted The Dialler Output has been disabled/enabled EM Input of Extinguishment Mod. activated EM Input of Extinguishment Mod. shorted or open EM Input of Extinguishment Mod. previously shorted or open EV Output of Extinguishment Mod. activated EV Output of Extinguishment Mod. shorted or open EV Output of Extinguish. [. . . ] Using Ú or Ù, select the new character. ZONE 1 Warehouse 4. Press Enter to save the Description on the screen and step back or, press Esc to save the Description on the screen and go back to the Main Menu. to the Descriptions the LCD + Any changes made broadcasted to the -- viaModules Module -- must be other by means of the Strings Update command. Using Ú or Ù, select Update Strings. LCD Module The LCD Module will allow you to program the following parameters from a J424 Control panel or from a J400-REP Repeater panel: Ø LCD Module Address Ø Zone Descriptions Ø Strings Update Ø Date Format To access the programming phase, insert the LCD Module jumper 82, the module will provide the Main menu. [. . . ]